Cobalt Base Alloys

Hazard statements (CLP)

H334

Code

Statements

H334

May cause allergy or asthma symptoms or breathing difficulties if inhaled

SECTION 2: Hazards identification

(29 CFR 1910.1200) Classification of the substance or mixture

2.2 Label elements

GHS US labeling

Signal word

Danger

Hazard statements

May cause an allergic skin reaction May cause allergy or asthma symptoms or breathing difficulties if inhaled. Suspected of causing genetic defects May cause cancer May damage fertility or the unborn child Causes damage to organs through prolonged or repeated exposure

Precautionary statements

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dust/fume/gas/mist/vapors/spray. Wash hands, forearms and face thoroughly after handling. Do not eat, drink or smoke when using this product. Contaminated work clothing must not be allowed out of the workplace. Wear protective gloves/protective clothing/eye protection/face protection. Wear respiratory protection. If exposed or concerned: Get medical advice/attention. If inhaled: If breathing is difficult, remove person to fresh air and keep comfortable for breathing. If experiencing respiratory symptoms: Call a poison center or doctor. If on skin: Wash with plenty of water. Wash contaminated clothing before reuse. If skin irritation or rash occurs: Get medical advice/attention. Store locked up. Dispose of contents/container to hazardous or special waste collection point, in accordance with local, regional, national and/or international regulation.

Other hazards which do not result in classification

No additional information available

Ingredient(s) with unknown acute toxicity

Not applicable

2.1 Classification of the substance or mixture

This product, as sold, has little or no immediate health or fire hazards. Under OSHA 29 CFR 1910.1200 Hazardous Communication Standard, steel products are considered mixtures since in solution, the two or more substances do not react. If product is welded, burned, sawed, brazed, ground, etc. potentially hazardous airborne particulate matter and fumes may be generated. Such activities should be performed in well-ventilated areas with appropriate PPE, as per PPE assessments for tasks involved. The classification given below pertains to the product during processing: GHS US classification Resp. Sens. 1 May cause allergy or asthma symptoms or breathing difficulties if inhaled. Skin Sens. 1 May cause an allergic skin reaction Muta. 2 Suspected of causing genetic defects Carc. 1B May cause cancer Repr. 1B May damage fertility or the unborn child STOT RE 1 Causes damage to organs through prolonged or repeated exposure