Adhered Masonry Stone Veneer (AMSV)

Hazard statements (CLP)

H315, H319, H372

Code

Statements

H315

Causes skin irritation

2.1 Classification of the substance or mixture

Adhered Masonry Stone Veneer (AMSV) are defined by OSHA as an article (under normal conditions, no more than minute or trace amounts of a hazardous chemicals are released and the article does not pose a physical hazard or health risk to employees). An SDS not is required for articles; however, this SDS is provided to communicate hazards associated where activities related to the Adhered Masonry Stone Veneer (cutting, grinding, crushing, drilling or breaking) may result in the release of a hazardous substance in DUST. GHS Classification(s) for Adhered Masonry Stone Veneer according to OSHA Hazard Communication Standard (29 CFR 1910.1200) under normal handling conditions: None Product: Adhered Masonry Stone Veneer (AMSV) SDS No: 001 Preparation Date 05/31/2015 Version no revision date 1.0 12/07/2015 GHS Classification(s) for dust generated from cutting, grinding, crushing, drilling or breaking of Adhered Masonry Stone Veneer according to OSHA Hazard Communication Standard (29 CFR 1910.1200) under use conditions that may result in the release of hazardous substances: Skin Corrosion/Irritation, Category 2 (H315) Eye Damage/Irritation, Category 2 (H319) Specific Target Organ Toxicity-Repeated Exposure (STOT-RE), Category 1 (H372) Note: The ASMV dust classifications are based on (1) individual ingredient classifications (i.e., Silica Sand [SiO2], pumice, expanded shale, expanded clay or expanded slate, Portland Cement, Fly Ash, etc.), (2) the final chemical composition of the AMSV (based on cement chemistry) and (3) the form of the material (dust). Further, the Specific Target Organ Toxicity-Repeat Exposure is a conservative classification based on the potential presence of respirable crystalline silica. Eldorado Stone has not performed analysis for the presence of respirable crystalline silica under these handling conditions.

Additional information

For full text of GHS Hazard statements (H-statements) and associated Precautionary statements (P- statements), see below.

2.2 Label elements

The Hazard Pictograms, Signal Word and Precautionary Statements only apply to activities that may release hazardous substances from the AMSV (i.e., cutting / grinding / crushing / drilling / breaking). No Hazard Pictograms, Signal Word or Precautionary Statements are applicable to the Adhered Masonry Stone Veneer. Hazard Pictograms that apply to the dust generated from cutting, grinding, crushing, drilling or breaking of the Adhered Masonry Stone Veneer:

Signal word

Danger

Hazard statements

H315: Causes skin irritation. (For AMSV Dust H319: Causes eye irritation. Generated from H372: Causes damage to lungs through prolonged or repeated Cutting, Grinding, inhalation exposure. Crushing, Drilling or Breaking)

Precautionary statements

P260: Do not breathe dust. (For AMSV Dust P270: Do not eat, drink or smoke while using this product. Generated from P271: Use only outdoors or in a well-ventilated area. Cutting, Grinding, P264: Wash thoroughly after handling. Crushing, Drilling or P280: Wear protective gloves/protective clothing/eye Breaking) protection/face protection. P302 + P352 IF ON SKIN Wash with plenty of water P304 + P340 IF INHALED Remove person to fresh air and keep comfortable for breathing. P305 + P351 + P338 IF IN EYES Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Product: Adhered Masonry Stone Veneer (AMSV) SDS No: 001 Preparation Date 05/31/2015 Version no revision date 1.0 12/07/2015 P314: Get medical advice/attention if you feel unwell. P321: See the SDS for specific treatment. P332 + P313: If skin irritation occurs, get medical advice/attention. P337 + 313: If eye irritation persists, get medical attention. P362 + P364: Take off contaminated clothing and wash before reuse. P501: Dispose of generated dust in accordance with local / regional / national / international regulations. 2.3 Other hazards related to AMSV dust generated from cutting, grinding, crushing, drilling or breaking of adhered masonry stone veneer. Listed Carcinogens: Silica dust (respirable, crystalline fraction) in the form of quartz. IARC: Yes NTP: Yes OSHA: No Other: No (European Union) Hazardous Properties: Dust generated from cutting, grinding, crushing, drilling or breaking may cause eye damage and skin irritation. May be irritating to respiratory tract. Respirable crystalline silica may cause damage to lungs upon repeated inhalation exposures.