Note: Ingredients listed on restricted chemical lists
EC/CAS
142844-00-6
Name of the chemical
Zirconia Aluminosilicate Refractory Ceramic Fibres
Concentration
the face.
General Information
Product name
Chico X Fiber/Chico X4/Chico X6/Chico X7
Product Synonyms
NA
CAS No.
142844-00-6
1.2.1 Relevant identified uses
Refractory ceramic fiber used to create a dam Unusual Fire or Explosion Hazards: Non-flammable and non- or plug for sealing compound combustible
1.2.2. Uses advised against
Not recommended for any use other than as SECTION 6: ACCIDENTAL RELEASE MEASURES advised above
Emergency telephone
(800) 424-9300
Icons in SDS
Company Information
company name
Eaton’s Crouse-Hinds Division
Section 2
SECTION 2: Hazards identification
GHS Classification This product is classified as an “article” in accordance with 29 CFR1910.1200(b)(6)(v) in the United States, and Section 12 of Canada’s Hazardous Products Act. Although safety data sheets are not required for articles, Eaton is providing you with these safe use recommendations so that you can understand the conditions for the safe use of this product. clean the work area with an appropriately filtered vacuum or wet sweeping to minimize the accumulation of debris. Do not use compressed air for clean-up. SECTION 7: HANDLING & STORAGE Precautions for Safe Handling: Handle fiber carefully to minimize Relevant Route of Exposure/Target Organs: None airborne dust. Limit use of power tools unless in conjunction with local OSHA/GHS Signal Word and Hazard Statements: Warning; Suspected of causing cancer by inhalation exhaust ventilation. Use hand tools whenever possible. Conditions for Safe Storage: Store in a manner to minimize airborne dust. GHS Classification and Pictograms Empty Containers: Product packaging may contain residue. Do not GHS Precautionary Statements: Prevention: Do not handle until all safety instructions have been read and understood. Use respiratory protection as required; see section 8 of the Safety Data Sheet. If concerned about exposure, get medical advice. Storage: Store in a manner to minimize airborne dust reuse EXPOSURE CONTROLS & PERSONAL PROTECTION Although this article is not anticipated to release quantities of hazardous chemicals that would produce a physical or health hazard, the following general exposure controls should be used as they would in any industrial environment. Disposal: Dispose of waste in accordance with local, state and federal regulations Engineering Controls/Ventilation: Use engineering controls such as local exhaust ventilation, point of generation dust collection, down draft work stations, emission controlling tool designs, and materials handling SECTION 3: COMPOSITION AND INFORMATION ON work stations, emission controlling tool designs, and materials handling equipment designed to minimize airborne fiber emissions. INGREDIENTS Eye Protection: As necessary, wear goggles or safety glasses that seal to COMPONENT CAS # % the face. Respiratory Protection: When engineering and/or administrative controls Refractories, Fibers, Aluminosilicate 142844-00-6 100 are insufficient to maintain workplace concentrations below the 0.5 f/cc REG or a regulatory OEL, the use of appropriate respiratory protection, pursuant to the requirements of 5 OSHA Standards 29 CFR 1910.134
2.1 Classification of the substance or mixture
Empty Containers: Product packaging may contain residue. Do not