Note: Ingredients listed on restricted chemical lists
EC/CAS
10117-38-1
Name of the chemical
Potassium sulphite
Concentration
N/A
EC/CAS
123-31-9
Name of the chemical
1,4-Dihydroxybenzol (790/2009)
Concentration
N/A
EC/CAS
7647-15-6
Name of the chemical
Sodium bromide
Concentration
N/A
EC/CAS
1310-58-3
Name of the chemical
potassium hydroxide
Concentration
N/A
General Information
Revision date
2015-03-17
Product name
KODAK ACCUMAX Rapid Access Developer and Replenisher
Product Synonyms
PCD 5166
1.2.1 Relevant identified uses
photographic processing chemical. For industrial use only
supplier name
EASTMAN KODAK COMPANY
Icons in SDS
Company Information
company name
EASTMAN KODAK COMPANY
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200: Classification of the chemical in accordance with paragraph (d) of 29 CFR 1910.1200:
Principle Routes of Exposure
Skin corrosion/irritation Category 2 -- Serious eye damage Category 1 -- Skin sensitisation Category 1 --
Contains
Hydroquinone (123-31-9), Sodium carbonate (497-19-8), Sodium bromide (7647-15-6), Ethylenediaminetetraacetic acid (60-00-4), Potassium hydroxide (1310-58-3)
Signal word
Danger
Hazard statements
Causes skin irritation. Causes serious eye damage. May cause an allergic skin reaction.
Prevention
Wear protective gloves/ eye protection/ face protection. Avoid breathing dust/ fume/ gas/ mist/ vapours/ spray. Wash thoroughly after handling. Contaminated work clothing should not be allowed out of the workplace.
Response
Immediately call a POISON CENTER or doctor/ physician. IF ON SKIN Wash with plenty of soap and water. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Take off contaminated clothing and wash before reuse.
Disposal
Dispose of contents/container in accordance with local/regional/national/international regulation. HMIS III Hazard Ratings: Health - 3, Flammability - 0, Physical Hazard - 0 NFPA Hazard Ratings: Health - 3, Flammability - 0, Instability - 0 NOTE: HMIS III and NFPA 704 (2007) hazard indexes involve data review and interpretation that may vary among companies. They are intended only for rapid, general identification of the magnitude of the potential hazards. To adequately address safe handling, ALL information in this MSDS must be considered.