DS-800 SOLVENT (SOLVENT, CLEANING, DEFOD P/N B6274-1)

Hazardous Ingredients

PROTECTION OSHA Hazards This product is hazardous as defined in 29 CFR1910.1200.

2.3 Other hazards

Combustible For additional information see Section 3 HEALTH INFORMATION & PROTECTION NATURE OF HAZARD EYE CONTACT: Slightly irritating but does not injure eye tissue. SKIN CONTACT: Low order of toxicity. Frequent or prolonged contact may irritate and cause dermatitis. Skin contact may aggravate an existing dermatitis condition. INHALATION: High vapor/aerosol concentrations (greater than approximately 1000 ppm) are irritating to the eyes and the respiratory tract, may cause headaches, dizziness, anesthesia, drowsiness, unconsciousness, and other central nervous system effects, including death. INGESTION: Small amounts of this product aspirated into the respiratory system during ingestion or vomiting may cause mild to severe pulmonary injury, possibly progressing to death. Minimal toxicity. FIRST AID EYE CONTACT: Flush eyes with large amounts of water until irritation subsides. If irritation persist, get medical attention. SKIN CONTACT: Flush with large amounts of water: use soap if available Remove grossly contaminated clothing, including shoes, and launder before reuse. INHALATION: Using proper respiratory protection, immediately remove the affected victim from exposure. Administer artificial respiration if breathing is stopped. Keep at rest. Call for prompt medical attention. INGESTION: If swallowed. Do not induce vomiting. Keep at rest. Get prompt medical attention. ACUTE TOXICITY DATA IS AVAILABLE UPON REQUEST WORKPLACE EXPOSURE LIMITS DYSOL RECOMMENDS THE FOLLOWING OCCUPATIONAL LIMITS: 300 ppm total hydrocarbon based on composition. PRECAUTIONS SPECIAL PRECAUTIONS: Health studies have shown that many petroleum hydrocarbons pose potential human health risks which may vary from person to person. As a precaution, exposure to liquids, vapors, mists or fumes should be minimized. PERSONAL PROTECTION: For open systems where contact is likely, wear safety glasses with side shields, long sleeves, and chemical resistant gloves. Where contact may occur, wear safety glasses with side shields. Where concentrations in air may exceed the limits given in this Section and engineering, work practice or other means of exposure reduction are not adequate, NIOSH/MSHA approved respirators may be necessary to prevent overexposure by inhalation. VENTILATION: The use of mechanical dilution ventilation is recommended whenever this product is used in a confined space, is heated above ambient temperatures, or is agitated. FIRE & EXPLOSION HAZARD FLASHPOINT: 104 Deg F. METHOD TCC NOTE Minimum FLAMMABLE LIMITS LEL 0.7 UEL 5.6 @ 77 Deg. F NOTE Approximate AUTOIGNITION TEMPERATURE 689 Deg. F. NOTE Approximate GENERAL HAZARD: Combustible Liquid, can form combustible mixtures at temperatures at or above the flashpoint. Static Discharge. material can accumulate static charges which can cause an incendiary electrical discharge. "Empty" containers retain product residue (liquid and/or vapor) and can be dangerous. Do not PRESSURIZE, CUT, WELD, BRAZE SOLDER, DRILL, GRIND, OR EXPOSE SUCH CONTAINERS TO HEAT, FLAME, SPARKS, STATIC ELECTRICITY, OR OTHER SOURCES OF IGNITION; THEY MAY EXPLODE AND CAUSE INJURY OR DEATH. Empty drums should be completely drained, properly bunged and promptly returned to a drum reconditioner, or properly disposed of.