Note: Ingredients listed on restricted chemical lists
EC/CAS
78-11-5
Name of the chemical
Pentaerithrityl tetranitrate (INN)
Concentration
N/A
EC/CAS
204-800-2/126-73-8
Name of the chemical
Tributyl phosphate
Concentration
22-40
EC/CAS
215-647-6/1336-21-6
Name of the chemical
ammonium hydroxide
Concentration
N/A
EC/CAS
201-084-3
Name of the chemical
Pentaerithrityl tetranitrate (INN)
Concentration
N/A
General Information
Revision date
2015-05-22
Product name
Detonating Cord, Specialty (Oil Field) (Class 1.4S)
Product Synonyms
8/40 RDX NYLON LS
1.2.2. Uses advised against
No further relevant information available
Icons in SDS
Company Information
company name
Dyno Nobel Inc
e-mail address of the competent person responsible for the Safety Data Sheet
dnna.hse@am.dynonobel.com
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H204
Hazard statements
Code
Statements
H204
Fire or projection hazard
Section 2
CLP CLASSIFICATION
Classifications listed also are applicable to the OSHA GHS Hazard Communication Standard (29CFR1910.1200). (Contd. of page 1) exploding bomb Expl. 1.4 H204 Fire or projection hazard.
EU Classification
Directive 67/548/EEC or Directive 1999/45/EC R5: Heating may cause an explosion. · Information concerning particular hazards for human and environment: The product has to be labelled due to the calculation procedure of the "General Classification guideline for preparations of the EU" in the latest valid version.
Classification system
The classification is according to the latest editions of the EU-lists, and extended by company and literature data. The classification is in accordance with the latest editions of international substances lists, and is supplemented by information from technical literature and by information provided by the company.
Additional information
There are no other hazards not otherwise classified that have been identified. 0 percent of the mixture consists of component(s) of unknown toxicity
2.2 Label elements
Labelling according to Regulation (EC) No 1272/2008 The product is additionally classified and labelled according to the Globally Harmonized System within the United States (GHS). The product is classified and labelled according to the CLP regulation.
Hazard pictograms
GHS01
Hazard statements
H204 Fire or projection hazard. · WHMIS-symbols: Explosive products are not classified under WHMIS. · NFPA ratings (scale 0 - 4) Not available. · HMIS-ratings (scale 0 - 4) Not available (Contd. of page 2) · HMIS Long Term Health Hazard Substances None of the ingredients are listed.
Precautionary statements
P210 Keep away from heat/sparks/open flames/hot surfaces. - No smoking. P250 Do not subject to grinding/shock/friction. P280 Wear protective gloves/protective clothing/eye protection/face protection. P240 Ground/bond container and receiving equipment. P373 DO NOT fight fire when fire reaches explosives. P370+P380 In case of fire: Evacuate area. P372 Explosion risk in case of fire. P401 Store in accordance with local/regional/national/international regulations. P501 Dispose of contents/container in accordance with local/regional/national/international regulations.
PBT Substances
Not applicable
vPvB Substances
Not applicable · Explosive Product Notice PREVENTION OF ACCIDENTS IN THE USE OF EXPLOSIVES - The prevention of accidents in the use of explosives is a result of careful planning and observance of the best known practices. The explosives user must remember that he is dealing with a powerful force and that various devices and methods have been developed to assist him in directing this force. He should realize that this force, if misdirected, may either kill or injure both him and his fellow workers. WARNING - All explosives are dangerous and must be carefully handled and used following approved safety procedures either by or under the direction of competent, experienced persons in accordance with all applicable federal, state, and local laws, regulations, or ordinances. If you have any questions or doubts as to how to use any explosive product, DO NOT USE IT before consulting with your supervisor, or the manufacturer, if you do not have a supervisor. If your supervisor has any questions or doubts, he should consult the manufacturer before use.