Note: Ingredients listed on restricted chemical lists
EC/CAS
80-62-6
Name of the chemical
methacrylic acid, methyl ester
Concentration
N/A
General Information
Revision date
2016-12-15
Product name
Corian Solid Surface Material
CAS No.
80-62-6
Icons in SDS
Company Information
company name
DuPont
GHS Information
Signal word
Warning
Section 2
SECTION 2: Hazards identification
Product hazard category Combustible dust Label content
Hazard pictograms
not required
Signal word
Warning Hazardous warnings : May form combustible dust concentrations in air. Hazardous prevention : Obtain special instructions before use. measures Do not handle until all safety precautions have been read and understood. Do not breathe dust/ fume/ gas/ mist/ vapours/ spray. Do not get in eyes, on skin, or on clothing. Wash skin thoroughly after handling. Do not eat, drink or smoke when using this product. Use only outdoors or in a well-ventilated area. Contaminated work clothing should not be allowed out of the workplace. Wear protective gloves/ protective clothing. Use personal protective equipment as required. Wear respiratory protection. IF ON SKIN: Gently wash with plenty of soap and water. IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. IF exposed or concerned: Get medical advice/ attention. Immediately call a POISON CENTER/doctor. If skin irritation or rash occurs: Get medical advice/ attention. Remove/Take off immediately all contaminated clothing. Store in a well-ventilated place. Keep container tightly closed. Store locked up. Dispose of contents/ container to an approved waste disposal plant.
2.3 Other hazards
The product as such is not hazardous., The hazards of this product are associated mainly with its processing., Operations such as sawing, routing, drilling and sanding can generate dust., WARNING!, May form combustible dust concentrations in air (during processing)., High concentrations of dust can irritate eyes, nose and respiratory system and cause coughing and sneezing., Corian® Solid Surface material does not emit gas at room temperature. At higher temperatures, small amounts of methyl methacrylate and butyl acrylate can be released. The amounts are dependent upon temperature, time and other variables. If small particles are generated during further processing, handling or by other means, may form combustible dust concentrations in air. Additives in this product do not present a respiration hazard unless the product is ground to a powder of respirable size and the dust is inhaled. All dusts are potentially injurious to the respiratory tract if respirable particles are generated and inhaled.
Ingredient(s) with unknown acute toxicity
100 %