Note: Ingredients listed on restricted chemical lists
EC/CAS
97-88-1
Name of the chemical
methacrylic acid, butyl ester
Concentration
N/A
General Information
Revision date
2018-08-29
Product name
NeoCryl B-842
CAS No.
97-88-1
supplier name
DSM Coating Resins, Inc
Icons in SDS
Company Information
company name
DSM Coating Resins, Inc
e-mail address of the competent person responsible for the Safety Data Sheet
DSMRESINS.SDS@dsm.com
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H317
Hazard statements
Code
Statements
H317
May cause an allergic skin reaction
Section 2
SECTION 2: Hazards identification
29 CFR 1910.1200) OSHA/HCS status : This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200).
2.1 Classification of the substance or mixture
COMBUSTIBLE DUSTS SKIN SENSITIZATION - Category 1
Signal word
Warning
Hazard statements
No Code(s) - May form combustible dust concentrations in air. H317 - May cause an allergic skin reaction.
Prevention
P280 - Wear protective gloves 4 - 8 hours (breakthrough time) nitrile rubber (0.5 mm) P261 - Avoid breathing dust. P272 (OSHA) - Contaminated work clothing must not be allowed out of the workplace.
Response
P302 + P352 + P363 - IF ON SKIN: Wash with plenty of soap and water. Wash contaminated clothing before reuse. P333 + P313 - If skin irritation or rash occurs: Get medical attention.
Storage
Not applicable.
Disposal
P501 - Dispose of contents and container in accordance with all local, regional, national and international regulations.
Supplemental label elements
Keep container tightly closed. Keep away from heat, hot surfaces, sparks, open flames elements and other ignition sources. No smoking. Prevent dust accumulation.
2.3 Other hazards
None known. HMIS® IV : Health / 2 Hazardous Material Flammability 3 Information System (U.S.A.)
Physical hazards
0 The PPE (Personal Protection Equipment) designation in the HMIS is provided for use by employees at supplier sites only. Other users of this product are encouraged to evaluate the hazards of the product and assign PPE that is applicable to their specific situations. Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or risks. Although HMIS® ratings and the associated label are not required on SDSs or products leaving a facility under 29 CFR 1910.1200, the preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS® program. HMIS® is a registered trademark and service mark of the American Coatings Association, Inc. The customer is responsible for determining the PPE code for this material. For more information on HMIS® Personal Protective Equipment (PPE) codes, consult the HMIS® Implementation Manual.
Remarks
Dust may cause mechanical irritation.
