Note: Ingredients listed on restricted chemical lists
General Information
Version
5
Revision date
2020-08-25
Product name
Air flow test tubes
CAS No.
7664-93-9
1.2.1 Relevant identified uses
Air quality test tubes Reserved for industrial and professional use
Emergency telephone
+1 800-437-2437, +49 (0)451 8...
Icons in SDS
Company Information
company name
Draeger Inc
e-mail address of the competent person responsible for the Safety Data Sheet
SDS@draeger.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H290, H314
Hazard statements
Code
Statements
H290
May be corrosive to metals
Section 2
SECTION 2: Hazards identification
This material is considered hazardous by the OSHA Hazard Communication Standard ( 29 CFR 1910. 1200 ) Emergency overview Appearance Form: Aerosol Color: whitish Odor stinging
2.1 Classification of the substance or mixture
Corrosive to Metals - Category 1. Skin Corrosion - Category 1A.
Signal word
Danger
Hazard statements
May be corrosive to metals. Causes severe skin burns and eye damage.
Precautionary statements
Keep only in original container. Do not breathe fume/gas/mist/vapors/spray. Wash hands and face thoroughly after handling. Wear protective gloves/protective clothing/eye protection/face protection. IF SWALLOWED: rinse mouth. Do NOT induce vomiting. IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/or shower. IF INHALED: Remove person to fresh air and keep comfortable for breathing. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER/doctor. Specific treatment (see ' First aid ' on this label). Wash contaminated clothing before reuse. Absorb spillage to prevent material damage. Store locked up. Store in corrosion resistant container/in container with a resistant inner liner. Dispose of contents/container to an appropriate recycling or disposal facility.
Additional information
This article contains hazardous substances or mixtures intended to be released under normal or reasonably foreseeable conditions of use. Classification/labeling: In case of release of ingredients (corrosive gases/vapors, Sulfuric acid)
2.3 Other hazards
Process vapors can irritate airways, skin and eyes. The vapors are heavier than air and can accumulate in high concentrations on the ground, in cavities, channels and cellars. Due to its pH value (see section 9), irritation of the skin and eyes cannot be ruled out. Information about Sulfuric acid Causes severe skin burns and eye damage. see section 11 Toxicological information
