Note: Ingredients listed on restricted chemical lists
EC/CAS
212-485-8/822-06-0
Name of the chemical
Hexamethylene diisocyanate
Concentration
< 0.3%
General Information
Revision date
2025-01-13
Product name
Cemflow Sealer Matt - Hardener
1.2.1 Relevant identified uses
Hardener part of two component waterbased polyurethane concrete \ and screed sealer
supplier name
Don Construction Products Ltd
Emergency telephone
+44 1 4407 66360
Icons in SDS
Company Information
company name
Don Construction Products Ltd
e-mail address of the competent person responsible for the Safety Data Sheet
Info@donconstruction.co.uk, info.uk@dcp-int.com
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H317, H332, H335
Hazard statements
Code
Statements
H317
May cause an allergic skin reaction
Section 2
SECTION 2: Hazards identification
Classification of the substance or mixture CLP: Acute Tox. 4, Skin Sens. 1, STOT SE 3
Hazard statements
H332 - Harmful if inhaled. H335 - May cause respiratory irritation. H317 - May cause an allergic skin reaction. Datasheet Number: C11/05/03/131-H - v2.0.0 1 EUH204 - Contains isocyanates. May produce an allergic reaction.
Precautionary statements
P304+P340 - IF INHALED: Remove person to fresh air and keep comfortable for breathing. P304+P312 - IF INHALED: Call a POISON CENTER or doctor/physician if you feel unwell. P403+P233 - Store in a well-ventilated place. Keep container tightly closed. P261 - Avoid breathing dust/fume/gas/mist/vapours/spray. P280 - Wear protective gloves/protective clothing/eye protection/face protection. P333+P313 - If skin irritation or rash occurs: Get medical advice/attention. P362+P364 - Take off contaminated clothing and wash it before reuse. P271 - Use only outdoors or in a well-ventilated area. P302+P352 - IF ON SKIN: Wash with plenty of soap and water. P405 - Store locked up. P272 - Contaminated work clothing should not be allowed out of the workplace.
Contains
Hydrophillic aliphatic polyisocyanate based on HDI Hexamethylene diisocyanate, oligomers - As from 24 August 2023 adequate training is required before industrial or professional use - In case of hypersensitivity of the respiratory tract (e.g. asthmatics and those who suffer from chronic bronchitis) it is inadvisable to work with the product. Symptoms affecting the respiratory tract can also occur several hours after overexposure. Dust, vapors and aerosols are the primary risk to the respiratory tract.
2.1 Classification of the substance or mixture
- CLP: Acute Tox. 4, Skin Sens. 1, STOT SE 3
