IR-270BKA PRINTING INK

Hazard statements (CLP)

H225, H319, H336, H412

Code

Statements

H225

Highly Flammable liquid and vapour

SECTION 2: Hazards identification

Physical hazards

Flam. Lig. 2 - H225

Health hazards

Eye Irrit. 2 - H319 STOT SE 3 - H336

Environmental hazards

Aquatic Chronic 3 ~ H412 Hurnan health See Section {1 for additional information on health hazards, Environmental The product contains a substance which may cause long-term adverse effects in the aquatic environment. wt General information Keep affected person away from heat, sparks and flames. Inhalation Move affected person to fresh air at once. If breathing stops, provide artificial respiration. Keep affected person warm and at rest. Get medical attention immediately. Ingestion Never give anything by mouth to an unconscious person. Do not induce vomiting. Do not induce vomiting. Get medical attention immediately. Skin Contact Remove affected person from source of contamination. Wash skin thoroughly with soap and water. Get medical attention if any discomfort continues. Eye contact Remove any contact lenses and open eyelids wide apart. Continue to rinse for at least 15 minutes. Continue to rinse for at least 15 minutes. Get medical attention immediately. Most important symptoms and effects, both acute and delayed General information The severity of the symptoms described will vary dependent on the concentration and the length of exposure. Inhalation Vapors may cause headache, fatigue, dizziness and nausea. Ingestion May cause nausea, headache, dizziness and intoxication. Skin contact Prolonged contact may cause redness, irritation and dry skin. Eye contact May cause severe eye irritation. Indication of immediate medical attention and special treatment needed Notes for the doctor No specific recommendations. If in doubt, get medical attention promptly. (8.Fire-fighting measures Extinguishing media Suitable extinguishing media Extinguish with alcohol-resistant foam, carbon dioxide or dry powder. Water spray. Special hazards arising from the substance or mbdure Specific hazards Fire creates Toxic gases/vapors/fumes of Carbon monoxide (CO). Carbon dioxide (CO2) Take precautionary measures against static discharges, Hazardous combustion Oxides of carbon, Thermal decomposition or combustion may fiberate carbon oxides and products other toxic gases or vapours. Advice for firefighters Protective actions during Control run-off water by containing and keeping it out of sewers and watercourses. If risk of firefighting water pollution occurs, notify appropriate authorities. Use water to keep fire exposed containers cool and disperse vapors. Move containers from fire area if it can be done without risk. 6. Accidental release measures Personal precautions, protective equipment and emergency procedures Personal precautions Wear protective clothing as described in Section 8 of this safety data sheet. Environmental precautions Do not discharge into drains or watercourses or onto the ground. Methods and material for containment and cleaning up Protective equipment Appropriate engineering All handling should only take place in well-ventilated areas. controls Eye/face protection Wear chemical splash goggles. Hand protection Chemical-resistant, impervious gloves complying with an approved standard should be worn if a risk assessment indicates skin contact is possible. It should be noted that liquid may penetrate the gloves. Frequent changes are recommended. Other skin and body Wear appropriate clothing to prevent any possibility of skin contact. protection Hyglene measures Use engineering controls to reduce air contamination to permissible exposure level. Provide eyewash station. Do not smoke in work area. Promptly remove any clothing that becomes wet or contaminated. Wash promptly if skin becomes contaminated. Use appropriate hand lotion to prevent defatting and cracking of skin. When using do not eat, drink or smoke. Wash hands at the end of each work shift and before eating, smoking and using the toilet. Respiratory protection No specific recommendations. Respiratory protection must be used if the airborne contamination exceeds the recommended occupational exposure limit. Environmental exposure Keep container tightly sealed when not in use. controls |9. Physical and Chemical Properties Information on basic physical and chemical properties Appearance Liquid. Color Black. Oder Ketonic. Initial boiling point and range ~75-85°C @°C @ 760 mm Hg Flash point -6°C CC (Closed cup), Vapour density > Relative density 0.865 @ @ 25°C Solubility(ies) Slightly soluble in water. Soluble in the following materials: Organic solvents.