Note: Ingredients listed on restricted chemical lists
EC/CAS
110-54-3
Name of the chemical
n-Hexan (790/2009)
Concentration
25%50%
EC/CAS
119-47-1
Name of the chemical
6,6'-di-tert-butyl-2,2'-methylenedi-p-cresol
Concentration
1%5%
EC/CAS
108-05-4
Name of the chemical
Vinylacetat (944/2013)
Concentration
1%5%
General Information
Version
3
Revision date
2018-10-18
Product name
Solvent Based Duct Sealer
Product name
Solvent Based Duct Sealer
Identification on the label/Trade name
ID’s 510901, 510906
Chemical name
Adhesive
supplier name
Design Polymerics
Emergency telephone
(800) 255-3924
Icons in SDS
Company Information
company name
Design Polymerics
GHS Information
Signal word
DANGER
Section 2
SECTION 2: Hazards identification
This material is considered hazardous by the OSHA Hazard Communication Standard ( 29 CFR 1910. 1200 ) Product Signal Word: DANGER
Precautionary statements
General: Read label before use. Keep out of reach of children. If medical advice is needed, have product container or label at hand.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Use personal protective equipment as required. Wear protective gloves. Wear eye or face protection. Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. Use explosion-proof electrical, ventilating, lighting and all material- handling equipment. Use only non-sparking tools. Take precautionary measures against static discharge. Keep container tightly closed. Use only outdoors or in a well-ventilated area. Avoid breathing vapor. Wash hands thoroughly after handling.
Response
If exposed or concerned Get medical attention. IF INHALED Remove victim to fresh air and keep at rest in a position comfortable for breathing. Call a POISON CENTER or physician if you feel unwell. IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water or shower. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical attention.
Storage
Store locked up. Store in a well-ventilated place. Keep cool
Disposal
Dispose of contents and container in accordance with all local, regional, national and international regulations
Supplemental label elements
Avoid contact with skin and clothing. Wash thoroughly after handling
2.3 Other hazards
Prolonged or repeated contact may dry skin and cause irritation
2.1 Classification of the substance or mixture
FLAMMABLE LIQUIDS - Category 2 EYE IRRITATION - Category 2A CARCINOGENICITY (inhalation) - Category 2 SPECIFIC TARGET ORGAN TOXICITY (SINGLE EXPOSURE) (Respiratory tract irritation) - Category 3 SPECIFIC TARGET ORGAN TOXICITY (SINGLE EXPOSURE) (Narcotic effects) - Category 3
