Note: Ingredients listed on restricted chemical lists
EC/CAS
811-97-2
Name of the chemical
1,1,1,2-Tetrafluoroethane
Concentration
N/A
EC/CAS
13674-84-5
Name of the chemical
Tris(2-chloro-1-methylethyl) phosphate
Concentration
N/A
EC/CAS
460-73-1
Name of the chemical
1,1,1,3,3-Pentafluoropropane
Concentration
N/A
EC/CAS
78-40-0
Name of the chemical
Phosphoric acid, triethyl ester, TEP
Concentration
N/A
General Information
Revision date
2019-08-19
Product name
FROTH-PAK Polyol INT 1.75 HFC Blend
1.2.1 Relevant identified uses
For industrial use Component(s) for the manufacture of urethane polymers. We recommend that you use this product in a manner consistent with the listed use. If your intended use is
Icons in SDS
Company Information
company name
ddp specialty electronic materials us, inc.
e-mail address of the competent person responsible for the Safety Data Sheet
SDSQuestion-NA@dupont.com
Section 2
OSHA HCS Classification
Gases under pressure - Liquefied gas Reproductive toxicity - Category 2
Hazard pictograms
Trademark of The Dow Chemical Company ("Dow") or an affiliated
Signal word
Contains gas under pressure; may explode if heated. Suspected of damaging fertility or the unborn child.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Wear protective gloves/ protective clothing/ eye protection/ face protection.
Response
IF exposed or concerned: Get medical advice/ attention.
Storage
Store locked up. Protect from sunlight. Store in a well-ventilated place.
Disposal
Dispose of contents/ container to an approved waste disposal plant.
2.3 Other hazards
No data available
