DAP DRYDEX SPACKLING (RTU)

SECTION 2: Hazards identification

CASRN WI'% ACGmTWA ACGm ~CGmCEIL

Principle Routes of Exposure

Skin Contact, Inhalation, Eye Contact Medical Conditions which May be Aggravated by Exposure: If dry sanded, asthma and asthma-like conditions may worsen from prolonged or repeated exposure to dust. ISection 4 - First Aid Measures First Aid - Eye Contact: In case of contact, immediately flush eyes with plenty of water for at least 15 minutes. Get medical attention immediately. First Aid - Skin Contact: Wash off immediately with soap and plenty of water. First Aid -Inhalation: If inhaled, remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention immediately. First Aid -Ingestion: Do not induce vomiting. Call a physician or Poison Control Center immediately. Note to Physician: None. COMMENTS: Call Medical Emergency at 1-800-327-3874 if any irritation or complication arises from any of the above routes of entry. Section 5 - Fire Fi Measures Flash Point, F: Greater than 200 degrees Lower Explosive Limit, %: Not Established Method: (Seta Closed Cup) Upper Explosive Limit, %: Not Established Extinguishing Media: Carbon Dioxide, Dry Chemical, Foam, Water Fog Unusual Fire And Explosion Hazards: None known. Special Firefighting Procedures: Cool fire -exposed containers using water spray. IISection 6 - Accidental Release Measures Steps To Be Taken If Material Is Released Or Spilled: Wear proper protective equipment as specified in Section 8. Scrape up dried material and place into containers. ~Section 7 - Handlins And Storage Handling: KEEP OUT OF REACH OF CHILDREN! Avoid contact with skin and eyes. Wash thoroughly after handling. Do not breathe dust. While dry sanding, use of a NIOSH-approved dust mask is recommended. Removal of this product after use will result in the generation of Dust. If dry-sanded, exposure to dust may result in the build-up of material in eyes, ears, nose, and mouth which may cause irritation. Avoid excessive heat and handling.

Storage

Store away from caustics and oxidizers. Do not store at temperatures above 120 degrees F. Keep tightly closed Avoid excessive heat and freezing. ~Section 8 - Exposure Controls I Personal Protection

Precautionary statements

Please refer to other sections and subsections of this MSDS Engineering Controls: Local ventilation of emission sources may be necessary to maintain ambient concentrations below recommended exposure limits. Wet sanding is recommended to avoid generation of dust. Prevent build-up of dust and vapors by opening windows and doors or use other means to ensure fresh air entry during application, drying and sanding. Respiratory

TOXICOLOGICAL INFORMATION

Product LC50: Not Established Chemical Name LDSO t:4 Om Carcinogenicity: Chemical Name ACGIH

ECOLOGICAL INFORMATION

Ecological injuries are not known or expected under normal use. ISection 13 • Disposal Information

Disposal

Information Dispose of material in accordance with all federal, state and local regulations. State and Local regulations/restrictions are complex and may differ from Federal regulations. Responsibility for proper waste disposal is with the owner of the waste. EPA Waste Code if Discarded (40 CFR Section 261): None tion 14 - Trans ortation Information DOT Proper Shipping Not Regulated Packing Group: NA Name: DOT Technical Name: N.A. Hazard Subclass: N.A. DOT Hazard Class: N.A. DOT UN/NA Number: N.A. Note: The shipping information provided is applicable for domestic ground transport only. Different categorization may apply if shipped via other modes of transportation and/or to non-domestic destinations.