Urethane and Plastic Mold Release Aerosol

Hazard statements (CLP)

H222, H280, H304, H315, H336, H361

Code

Statements

H222

Extremely flammable aerosol

SECTION 2: Hazards identification

Health hazards

Flammable aerosol Category 1 Skin corrosion/irritation Category 2 Gases under pressure Compressed gas Reproductive toxicity Category 2 Specific target organ toxicity – Single exposure, Category 3, Narcosis Aspiration hazard Category 1 GHS US labeling: Danger!

Precautionary statements

H222 - Extremely flammable aerosol H280 - Contains gas under pressure; may explode if heated H304 - May be fatal if swallowed and enters airways H315 - Causes skin irritation H336 - May cause drowsiness or dizziness H361 - Suspected of damaging fertility or the unborn child P201 - Obtain special instructions before use. P202 - Do not handle until all safety precautions have been read and understood. P210 - Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. P211 - Do not spray on an open flame or other ignition source. P251 - Pressurized container: Do not pierce or burn, even after use. P261 - Avoid breathing vapors, spray. P264 - Wash hands thoroughly after handling. P271 - Use only outdoors or in a well-ventilated area. P280 - Wear protective gloves, eye protection. P301+P310 - If swallowed: Immediately call a poison center or doctor. P331 - Do NOT induce vomiting. P302+P352 - If on skin: Wash with plenty of soap and water. P332+P313 - If skin irritation occurs: Get medical advice/attention. P362+P364 - Take off contaminated clothing and wash it before reuse. P304+P340 - If inhaled: Remove person to fresh air and keep comfortable for breathing. P312 - Call a poison center or doctor if you feel unwell. P308+P313 - If exposed or concerned: Get medical P403 - Store in a well-ventilated place. P405 - Store locked up. P410+P412 - Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. P501 - Dispose of contents/container to an approved waste disposal plant.