Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
General Information
Revision date
2016-08-23
Product name
Hebel Mortar (for NZ)
Emergency telephone
111 Police, Ambulance and Fire Brigade (available in NZ only
Icons in SDS
Company Information
company name
CSR Building Products (NZ) Limited (trading as CSR Hebel)
e-mail address of the competent person responsible for the Safety Data Sheet
info@csrhebel.co.nz
GHS Information
Signal word
Warning
Hazard Codes
Hazard statements (CLP)
H315, H317, H319, H335, H373
Hazard statements
Code
Statements
H315
Causes skin irritation
H317
May cause an allergic skin reaction
H319
Causes serious eye irritation
H335
May cause respiratory irritation
H373
May cause damage to organs through prolonged or repeated exposure
Section 2
Hazard statements
Classified as Hazardous according to the New Zealand Environmental Protection Authority. Hebel Mortar has been approved under the Hazardous Substances and New Organisms Act (HSNO) as Construction Products (Toxic [6.7]) Group Standard 2006 and is classified as follows: 6.3A Substances that are irritating to the skin 6.4A Substances that are irritating to the eye 6.5B Substances that are contact sensitizers 6.7B Substances that are suspected human carcinogens 6.9A Substances that are toxic to human target organs or systems Hebel Mortar is classified as Non-Dangerous Goods according to the NZ Transport of Dangerous Goods on Land.
Hazard pictograms
Skin Irritation Category 2 Skin Sensitisation Category 1 WARNING Eye Irritation Category 2A Specific Target Organ Toxicity (Single Exposure) Category 3 Specific Target Organ Toxicity (Repeated Exposure) Category 2
Precautionary statements
H315 – Causes skin irritation P260 – Do not breathe dust. H317 – May cause an allergic skin reaction P264 – Wash thoroughly after handling. H319 – Causes serious eye irritation P271 – Use only outdoors or in a well-ventilated area. H335 – May cause respiratory irritation P272 – Contaminated work clothing should not be allowed out of the H373 – May cause damage to organs through workplace. prolonged or repeated exposure by inhalation P280 – Wear protective gloves and eye/face protection. AUH066 – Repeated exposure may cause skin P302 + P352 – If on skin, wash with plenty of soap and water. dryness and cracking P304 + P340 – If inhaled, remove victim to fresh air and keep at rest in a position comfortable for breathing. P305 + P351 + P338 – If in eyes, rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P312 – Call a Poison Centre or doctor if you feel unwell. P333 + P313 – If skin irritation or rash occurs, get medical advice/attention. P337 + P313 – If eye irritation persists, get medical advice/attention. P362 – Take off contaminated clothing and wash before reuse. P403 + P233 – Store in a well-ventilated place and keep container tightly closed. A low proportion of the fine dust in the supplied dry product will be respirable crystalline silica. Once wetted, in the wet or final set form, risk of any airborne respirable dust will be low, but dry residues, or dust from cutting, grinding, abrading or finishing the set product may contain respirable crystalline silica.