Codes/Trade Names Not Applicable

Hazard statements (CLP)

H315, H317, H319, H335, H373

Code

Statements

H315

Causes skin irritation

Hazard statements

Classified as Hazardous according to the Approved Criteria For Classifying

Hazardous Ingredients

NOHSC 1008] 3rd Edition Hebel Mortar is classified as Non-Dangerous Goods according to the Australian Code for the Transport of Dangerous Goods by Road and Rail.

Hazard pictograms

Skin Irritation Category 2 Skin Sensitisation Category 1 WARNING Eye Irritation Category 2A Specific Target Organ Toxicity (Single Exposure) Category 3 Specific Target Organ Toxicity (Repeated Exposure) Category 2

Precautionary statements

H315 – Causes skin irritation P260 – Do not breathe dust. H317 – May cause an allergic skin reaction P264 – Wash thoroughly after handling. H319 – Causes serious eye irritation P271 – Use only outdoors or in a well-ventilated area. H335 – May cause respiratory irritation P272 – Contaminated work clothing should not be allowed out of the H373 – May cause damage to organs through workplace. prolonged or repeated exposure by inhalation P280 – Wear protective gloves and eye/face protection. AUH066 – Repeated exposure may cause skin P302 + P352 – If on skin, wash with plenty of soap and water. dryness and cracking P304 + P340 – If inhaled, remove victim to fresh air and keep at rest in a position comfortable for breathing. P305 + P351 + P338 – If in eyes, rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P312 – Call a Poison Centre or doctor if you feel unwell. P333 + P313 – If skin irritation or rash occurs, get medical advice/attention. P337 + P313 – If eye irritation persists, get medical advice/attention. P362 – Take off contaminated clothing and wash before reuse. P403 + P233 – Store in a well-ventilated place and keep container tightly closed. A low proportion of the fine dust in the supplied dry product will be respirable crystalline silica. Once wetted, in the wet or final set form, risk of any airborne respirable dust will be low, but dry residues, or dust from cutting, grinding, abrading or finishing the set product may contain respirable crystalline silica.