Cronatron 345 Tool Steel TIG Wire

Hazard statements (CLP)

H317, H350, H372

Code

Statements

H317

May cause an allergic skin reaction

SECTION 2: Hazards identification

OSHA Hazards Hazard Classification Solid metallic products are generally classified as 'articles' and do not constitute a

Signal word

DANGER

Hazard statements

H317 - May cause an allergic skin reaction H350 - May cause cancer H372 - Causes damage to organs through prolonged or repeated exposure

Prevention

P201 - Obtain special instructions before use P202 - Do not handle until all safety precautions have been read and understood P260 - Do not breathe dust/fume/gas/mist/vapors/spray P261 - Avoid breathing dust/fume/gas/mist/vapors/spray P264 - Wash skin thoroughly after handling P270 - Do not eat, drink or smoke when using this product P272 - Contaminated work clothing should not be allowed out of the workplace P280 - Wear protective gloves/protective clothing and eye/face protection

Response

General P314 - Get medical advice/attention if you feel unwell. P321 - Specific treatment (see supplemental first aid instructions on this label) Skin P302 + P352 - IF ON SKIN: Wash with plenty of soap and water P333 + P313 - If skin irritation or rash occurs: Get medical advice/attention P362 - Take off contaminated clothing and wash before reuse

Storage

P405 - Store locked up

Disposal

P501 - Dispose of contents/container in accordance with local, regional, national, and international regulations as applicable Hazard(s) Not Otherwise None known. Classified (HNOC) Physical Hazards Not None known Otherwise Classified (PHNOC) Unknown acute toxicity None known.

2.1 Classification of the substance or mixture

Solid metallic products are generally classified as 'articles' and do not constitute a hazardous material in solid form under the definitions of the OSHA Hazard Communication Standard (29 CFR 1910.1200). Any articles manufactured from these solid products would be generally classified as non-hazardous. Some hazardous elements contained in these products can be emitted under certain processing conditions such as but not limited to : burning, melting, cutting, sawing, brazing, grinding, machining, milling, and welding. Products in the solid state present no fire or explosion hazard. Small chips, fines, and dust may ignite readily, though. The following classification information is for the hazardous elements which may be released during processing. Skin sensitization Category 1 Carcinogenicity Category 1B Specific target organ toxicity (repeated exposure) Category 1 Symbol Signal word DANGER Hazard statements H317 - May cause an allergic skin reaction H350 - May cause cancer H372 - Causes damage to organs through prolonged or repeated exposure