Weld Check Developer

CRC Industries, Inc

Revision date : 2014-11-20

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.
GHS04 GHS07 GHS02
Health risk rating 2
Safety risk rating 4
Environmental risk rating 1

Note: Ingredients listed on restricted chemical lists

EC/CAS

68476-86-8

Name of the chemical

Petroleum gases, liquefied, sweetened

Concentration

20-30

EC/CAS

14807-96-6

Name of the chemical

Talc

Concentration

5-10

General Information

Revision date

2014-11-20

Product name

Weld Check Developer

1.2.1 Relevant identified uses

Developer for non-destructive weld testing

Emergency telephone

800-424-9300, 703-527-3887

Icons in SDS

GHS02 GHS04 GHS07 M004 M009 M010 M011 M017

Company Information

company name

CRC Industries, Inc

GHS Information

Signal word

Danger

Hazard Codes

Hazard statements (CLP)

H222, H229, H280, H319, H336

Hazard statements

Code

Statements

H222

Extremely flammable aerosol

Section 2

SECTION 2: Hazards identification

Physical hazards

Flammable aerosols Category 1 Gases under pressure Liquefied gas

Health hazards

Serious eye damage/eye irritation Category 2 Specific target organ toxicity, single exposure Category 3 narcotic effects

Environmental hazards

Not classified.

Signal word

Danger

Hazard statements

Extremely flammable aerosol. Contains gas under pressure; may explode if heated. Causes serious eye irritation. May cause drowsiness or dizziness.

Prevention

Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Do not apply while equipment is energized. Pressurized container: Do not pierce or burn, even after use. Extinguish all flames, pilot lights and heaters. Vapors will accumulate readily and may ignite. Use only with adequate ventilation; maintain ventilation during use and until all vapors are gone. Open doors and windows or use other means to ensure a fresh air supply during use and while product is drying. If you experience any symptoms listed on this label, increase ventilation or leave the area. Avoid breathing mist or vapor. Avoid breathing gas. Wash thoroughly after handling. Wear eye/face protection.

Response

If inhaled: Remove person to fresh air and keep comfortable for breathing. Call a poison center/doctor if you feel unwell. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical attention.

Storage

Store in a well-ventilated place. Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Exposure to high temperature may cause can to burst.

Disposal

Dispose of contents/container in accordance with local/regional/national regulations. Hazard(s) not otherwise Static accumulating flammable liquid can become electrostatically charged even in bonded and

Classified (HNOC)

grounded equipment. Sparks may ignite liquid and vapor. May cause flash fire or explosion.

SDS Library

Move your SDS library online today

Check Icon
Setup – Easy setup with our database of 16 million+ SDSs
Check Icon
Up-to-date – Your SDS get updated to latest versions.
Check Icon
Employee access – Tablets, Smartphones, or link from Corporate Intranet
Check Icon
Safety – One-click access to first aid information.
Check Icon
Labels – Generate Secondary Container Labels with just one click.