Silicone Mold Release

Hazard statements (CLP)

H223, H229, H280, H315, H319, H335, H336, H351, H360, H373, H402, H412

Code

Statements

H223

Flammable aerosol

SECTION 2: Hazards identification

Physical hazards

Flammable aerosols Category 2 Gases under pressure Liquefied gas

Health hazards

Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2 Carcinogenicity Category 2 Reproductive toxicity Category 1B Specific target organ toxicity, single exposure Category 3 respiratory tract irritation Specific target organ toxicity, single exposure Category 3 narcotic effects Specific target organ toxicity, repeated Category 2 (kidney, liver, nervous system) exposure

Environmental hazards

Hazardous to the aquatic environment, acute Category 3 Hazardous to the aquatic environment, Category 3

Signal word

Danger

Hazard statements

Flammable aerosol. Contains gas under pressure; may explode if heated. Causes skin irritation. Causes serious eye irritation. May cause respiratory irritation. May cause drowsiness or dizziness. Suspected of causing cancer. May damage fertility or the unborn child. May cause damage to organs (kidney, liver, nervous system) through prolonged or repeated exposure. Harmful to aquatic life. Harmful to aquatic life with long lasting effects.

Prevention

Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Use with adequate ventilation. Open doors and windows or use other means to ensure a fresh air supply during use and while product is drying. If you experience any symptoms listed on this label, increase ventilation or leave the area. Do not breathe mist or vapor. Wear protective gloves/protective clothing/eye protection/face protection. Wash thoroughly after handling. Avoid release to the environment.

Response

If on skin Wash with plenty of water. If skin irritation occurs Get medical attention. Take off contaminated clothing and wash before reuse. If inhaled: Remove person to fresh air and keep comfortable for breathing. Call a poison center/doctor if you feel unwell. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists Get medical attention. If exposed or concerned Get medical attention.

Storage

Store in a well-ventilated place. Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Exposure to high temperature may cause can to burst.

Disposal

Dispose of contents/container in accordance with local/regional/national regulations. Hazard(s) not otherwise None known.

Additional information

When exposed to extreme heat or hot surfaces, vapors may decompose to harmful or fatal corrosive gases such as hydrogen bromide.