Note: Ingredients listed on restricted chemical lists
EC/CAS
811-97-2
Name of the chemical
1,1,1,2-Tetrafluoroethane
Concentration
40-50
EC/CAS
63148-62-9
Name of the chemical
polydimethylsiloxane (Mw > 6 800 Da)
Concentration
5-10
General Information
Revision date
2016-12-28
Product name
Heavy Duty Silicone Mold Release
Emergency telephone
703-527-3887
Icons in SDS
Company Information
company name
CRC Industries, Inc
GHS Information
Signal word
Warning
Section 2
Physical hazards
Flammable aerosols Category 2 Gases under pressure Liquefied gas
Health hazards
Not classified.
Environmental hazards
Hazardous to the aquatic environment, acute Category 3 Hazardous to the aquatic environment, Category 3
Long term hazards
OSHA defined hazards Not classified.
Signal word
Warning
Hazard statements
Flammable aerosol. Contains gas under pressure; may explode if heated. Harmful to aquatic life. Harmful to aquatic life with long lasting effects.
Prevention
Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Use with adequate ventilation. Open doors and windows or use other means to ensure a fresh air supply during use and while product is drying. Avoid release to the environment.
Response
Wash hands after handling.
Storage
Store in a well-ventilated place. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Exposure to high temperature may cause can to burst.
Disposal
Dispose of contents/container in accordance with local/regional/national regulations. Hazard(s) not otherwise None known.
Additional information
When exposed to extreme heat or hot surfaces, vapors may decompose to harmful or fatal corrosive gases such as hydrogen fluoride.
