Note: Ingredients listed on restricted chemical lists
EC/CAS
106-97-8
Name of the chemical
n-Butan, enthält 0,1% Butadien
Concentration
20-30
EC/CAS
1317-33-5
Name of the chemical
molybdenum disulphide
Concentration
1-3
EC/CAS
108-88-3
Name of the chemical
Toluene
Concentration
<0.3
General Information
Revision date
2017-12-12
Product name
Dry Moly Lube
Emergency telephone
800-424-9300, 703-527-3887
Icons in SDS
Company Information
company name
CRC Industries, Inc
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H222, H229, H280, H304, H319, H335, H336, H361d, H373, H402, H412
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
Section 2
SECTION 2: Hazards identification
Physical hazards
Flammable aerosols Category 1 Gases under pressure Liquefied gas
Health hazards
Serious eye damage/eye irritation Category 2A Reproductive toxicity (the unborn child) Category 2 Specific target organ toxicity, single exposure Category 3 respiratory tract irritation Specific target organ toxicity, single exposure Category 3 narcotic effects Specific target organ toxicity, repeated Category 2 exposure Aspiration hazard Category 1
Environmental hazards
Hazardous to the aquatic environment, acute Category 3 hazard Hazardous to the aquatic environment, Category 3
Signal word
Danger
Hazard statements
Extremely flammable aerosol. Contains gas under pressure; may explode if heated. May be fatal if swallowed and enters airways. Causes serious eye irritation. May cause respiratory irritation. May cause drowsiness or dizziness. Suspected of damaging the unborn child. May cause damage to organs through prolonged or repeated exposure. Harmful to aquatic life. Harmful to aquatic life with long lasting effects.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Do not breathe mist or vapor. Do not apply while equipment is energized. Extinguish all flames, pilot lights and heaters. Vapors will accumulate readily and may ignite. Use only with adequate ventilation; maintain ventilation during use and until all vapors are gone. Open doors and windows or use other means to ensure a fresh air supply during use and while product is drying. If you experience any symptoms listed on this label, increase ventilation or leave the area. Wash thoroughly after handling. Wear protective gloves/protective clothing/eye protection/face protection. Avoid release to the environment.
Response
If swallowed: Immediately call a poison center/doctor. Do NOT induce vomiting. If inhaled: Remove person to fresh air and keep comfortable for breathing. Call a poison center/doctor if you feel unwell. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. If exposed or concerned: Get medical advice/attention.
Storage
Store in a well-ventilated place. Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Exposure to high temperature may cause can to burst.
Disposal
Dispose of contents/container in accordance with local/regional/national regulations. Hazard(s) not otherwise None known. classified (HNOC)
Additional information
None.
2.1 Classification of the substance or mixture
Category 1 Environmental hazards Hazardous to the aquatic environment, acute Category 3 hazard Hazardous to the aquatic environment, Category 3 long-term hazard OSHA defined hazards Not classified.