Note: Ingredients listed on restricted chemical lists
EC/CAS
64742-49-0
Name of the chemical
Naphtha (petroleum), hydrotreated light
Concentration
N/A
EC/CAS
106-97-8
Name of the chemical
n-Butan, enthält 0,1% Butadien
Concentration
N/A
EC/CAS
67-56-1
Name of the chemical
Methanol
Concentration
N/A
EC/CAS
64742-89-8
Name of the chemical
Solvent naphtha (petroleum), light aliph
Concentration
N/A
General Information
Revision date
2019-08-05
Product name
Boron Nitride Mold Release - 10 oz
Emergency telephone
800-424-9300 (US
Icons in SDS
Company Information
company name
CRC Industries, Inc
GHS Information
Signal word
Danger
Section 2
Physical hazards
Flammable aerosols Category 1 Gases under pressure Liquefied gas Eealth hazards Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2A Specific target organ toxicity, single exposure Category 1 Specific target organ toxicity, single exposure Category 3 respiratory tract irritation Specific target organ toxicity, single exposure Category 3 narcotic effects Specific target organ toxicity, repeated Category 2 exposure
Aspiration hazard
Category 1
Environmental hazards
Hazardous to the aquatic environment, acute Category 2 Hazardous to the aquatic environment, Category 2
Long term hazards
OSEA defined hazards Not classified.
Signal word
Danger Eazard statement Extremely flammable aerosol. Contains gas under pressure; may explode if heated. May be fatal if swallowed and enters airways. Causes skin irritation. Causes serious eye irritation. May cause respiratory irritation. May cause drowsiness or dizziness. Causes damage to organs. May cause damage to organs through prolonged or repeated exposure. Toxic to aquatic life. Toxic to aquatic life with long lasting effects.
Prevention
Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Do not breathe mist/vapors. Do not apply while equipment is energized. Extinguish all flames, pilot lights, and heaters. Vapors will accumulate readily and may ignite. Use only with adequate ventilation; maintain ventilation during use and until all vapors are gone. Open doors and windows or use other means to ensure a fresh air supply during use and while product is drying. If you experience any symptoms listed on this label, increase ventilation or leave the area. Wash thoroughly after handling. Do not eat, drink or smoke when using this product. Wear eye protection/face protection. Wear protective gloves. Avoid release to the environment.
Response
If exposed Call a poison center/doctor. If swallowed Immediately call a poison center/doctor. Do NOT induce vomiting. If on skin Wash with plenty of water. If skin irritation occurs Get medical advice/attention. Take off immediately all contaminated clothing and wash it before reuse. If inhaled: Remove person to fresh air and keep comfortable for breathing. Call a poison center/doctor if you feel unwell. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Collect spillage.
Storage
Store in a well-ventilated place. Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Exposure to high temperature may cause can to burst.
Disposal
Dispose of contents/container in accordance with local/regional/national regulations. Eazard(s) not otherwise None known. classified (ENOC)
Additional information
None.