Note: Ingredients listed on restricted chemical lists
EC/CAS
106-97-8
Name of the chemical
n-Butan, enthält 0,1% Butadien
Concentration
10-20
General Information
Version
01
Revision date
2016-06-10
Product name
TERAND CUTTING AND TAPPING FLUID
1.2.1 Relevant identified uses
Lubricant
Emergency telephone
1-866-836-8855, 1-952-852-4646
Icons in SDS
Company Information
company name
CPC
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H222, H229, H319, H336
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
Section 2
SECTION 2: Hazards identification
Physical hazards
Flammable aerosols Category 1
Health hazards
Serious eye damage/eye irritation Category 2A Specific target organ toxicity, single exposure Category 3 narcotic effects
Signal word
Danger
Hazard statements
Extremely flammable aerosol. Causes serious eye irritation. May cause drowsiness or dizziness.
Prevention
Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Do not spray on an open flame or other ignition source. Pressurized container: Do not pierce or burn, even after use. Avoid breathing gas. Wash thoroughly after handling. Use only outdoors or in a well-ventilated area. Wear eye protection/face protection.
Response
If inhaled Remove person to fresh air and keep comfortable for breathing. If in eyes Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Call a poison center/doctor if you feel unwell. If eye irritation persists: Get medical advice/attention.
Storage
Store in a well-ventilated place. Keep container tightly closed. Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F.
Disposal
Dispose of contents/container in accordance with local/regional/national/international regulations. Hazard(s) not otherwise None known.
Additional information
None.
