Note: Ingredients listed on restricted chemical lists
EC/CAS
7732-18-5
Name of the chemical
Water, distilled, conductivity or of similar purity H2O
Concentration
92%
General Information
Revision date
2015-03-18
Product name
Mold & Mildew Stain Remover
Manufacturer Name
Corcraft - New York State Department of Corrections and
Emergency telephone
800-467-4922 (CHEMTREC) THE CHEMTREC NUMBER IS TO BE
Icons in SDS
Company Information
company name
Corcraft - New York State Department of Corrections and
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H314, H401
Hazard statements
Code
Statements
H314
Causes severe skin burns and eye damage.
H401
Toxic to aquatic life
Section 2
SECTION 2: Hazards identification
OSHA EMERGENCY OVERVIEW: This product is a clear liquid with a slight chlorine odor.
Health hazards
May cause irritation of the skin. Contact with skin may cause an allergic reaction Flammability Hazards: This product is a nonflammable liquid. Reactivity Hazards: None known.
Environmental hazards
The Environmental effects of this product have not been investigated, however release may cause adverse environmental effects.
Hazard pictograms
US DOT SYMBOL(S)
Signal word
2.1 GHS LABELING AND HAZARD CLASSIFICATION: This product does meet the definition of a hazardous substance or preparation as defined by Health Canada and the OSHA (as described in 29 CFR 1910.1200(d)) Component(s) Contributing to Classification(s) Sodium Hypochlorite
Classification according to GHS
Skin Corrosion, Category 1B Acute aquatic toxicity, Category 2
Storage
H314 Causes severe skin burns and eye damage P405 Store locked up. H401 Toxic to aquatic life
Disposal
P501 Dispose of contents/container in accordance with local/regional/national/international regulations.
Response
P280 Wear protective gloves/eye protection/face P303+P361+P353 IF ON SKIN (or hair): Take off protection. immediately all contaminated clothing. Rinse skin with P264 Wash thoroughly after handling. water/shower. P260 Do not breathe dusts or mists. P301+P330+P331 IF SWALLOWED: Rinse mouth. Do P272 Contaminated work clothing should not be allowed NOT induce vomiting. out of the workplace P363 Wash contaminated clothing before reuse. P271 Use only outdoors or in a well-ventilated area P304+P340 IF INHALED: Remove person to fresh air P273 Avoid release to the environment and keep comfortable for breathing. P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P310 Immediately call a POISON CENTER/doctor. 2.3 HEALTH HAZARDS OR RISKS FROM EXPOSURE: SYMPTOMS OF OVEREXPOSURE BY ROUTE OF EXPOSURE: The most significant routes of overexposure for this product are by contact with skin or eyes. The symptoms of overexposure are described in the following paragraphs. ACUTE: INHALATION: Mist or spray may cause coughing, headache, throat and respiratory irritation. CONTACT WITH SKIN: Corrosive material may cause redness, skin burns, or blisters. EYE CONTACT: Corrosive material may cause irritation with possible burns and tissue damage. INGESTION: May cause gastrointestinal irritation, vomiting, or headache. CHRONIC: None known TARGET ORGANS Acute Skin, Eyes Chronic: None known