MINERAL

Precautionary statements

may be necessary to dissipate static electricity for non-conductive containers. Use proper bonding and grounding during product transfer as described in National Fire Protection Association document NFPA 77. Hydrecarbon solvents are basically non-conductors of electricity and can become electrostatically charged during mixing, filtering or pumping at high flow rates. If this charge reaches a sufficiently high level, sparks can form that may ignite the vapors of flammable liquids. Warning. Sudden release of hot organic chemical vapors or mists from process equipment operating at elevated temperature and pressure, or sudden ingress of air into vacuum equipment, may result in ignitions without the presence of obvious ignition sources. Published "autoignition” or "ignition" temperature values cannot be treated as safe operating temperatures in chemical processes without analysis of the actual process conditions. Any use of this product in elevated temperature processes should be thoroughly evaluated to establish and maintain safe operating conditions. Continued on next page 66 1% AROMATICS 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Eye Protection Chemical splash goggles in compliance with OSHA regulations are advised; however, OSHA regulations also permit other type safety glasses. Consult your safety representative. Skin Protection Wear resistant gloves (consult your safety equipment supplier). To prevent repeated or prolonged skin contact, wear impervious clothing and boots. Respiratory Protections If workplace exposure limit(s) of product or any component is exceeded (see exposure guidelines), a NIOSH/MSHA approved air supplied respirator is advised in absence of proper environmental control. OSHA regulations also permit other NIOSH/MSHA respirators (negative pressure type) under specified conditions (see your industrial hygienist). Engineering or administrative controls should be implemented to reduce exposure. Engineering Controls Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below TLV(s).- Exposure Guidelines Component ALIPHATIC HYDROCARBONS (STODDARD TYPE) (8052-41-3)} OSHA PEL 500.000 ppm - TWA OSHA VPEL 100.000 ppm - TWA ACGIH TLV 100.000 ppm - TWA 9. PHYSICAL AND CHEMICAL PROPERTIES Boiling Point (for product) 300.0 - 400.0 F (148.8 - 204.4 cy @ 760 mmEg Continued on next page Prepared: 66 1% AROMATICS Vapor Pressure (for product) .540 mmHg #@ 68.00 F Specific Vapor Density 4.900 @ AIR=1 Specific Gravity -772 @ 60.00 F Liquid Density 6.440 lbs/gal @ 60.00 F -772 kg/1l @ 16.00 ¢ Percent Volatiles 100.0 % Volatile Organica Compounds (VOC) 772.000 g/l 6.440 lbs/gal Evaporation Rate -~15 (n-BuAcet=1 } Appearance No data State LIQUID Physical Form HOMOGENEOUS SOLUTION Color CLEAR, SAYBOLT COLOR 30 MIN Odor Wo data pH Not applicable Continued on next page 66 1% AROMATICS 10. STABILITY AND