Note: Ingredients listed on restricted chemical lists
EC/CAS
64742-52-5
Name of the chemical
Distillates (petroleum), hydrotreated heavy naphthenic
Concentration
N/A
EC/CAS
198840-65-2
Name of the chemical
Tetradecane, chloro derivs
Concentration
N/A
EC/CAS
112-34-5
Name of the chemical
2-(2-butoxyethoxy)ethanol
Concentration
N/A
EC/CAS
127087-87-0
Name of the chemical
Nonylphenolethoxylates (NPEO)
Concentration
N/A
EC/CAS
68608-26-4
Name of the chemical
Sulfonic acids, petroleum, sodium salts
Concentration
N/A
General Information
Revision date
2021-09-01
Product name
MILFORM 635
1.2.1 Relevant identified uses
STAMPING AND DRAWING FLUID
Emergency telephone
1-703-527-3887 (CHEMTREC
Icons in SDS
Company Information
company name
CIMCOOL Industrial Products LLC
GHS Information
Signal word
Warning
Section 2
Physical hazards
Not classified.
Health hazards
Skin irritation Category 2 Serious eye irritation Category 2 Sensitization, skin Category 1
Environmental hazards
Not classified. OSHA defined hazards Not classified.
Signal word
Warning
Hazard statements
Causes skin irritation. May cause an allergic skin reaction. Causes serious eye irritation.
Prevention
Wash thoroughly after handling. Contaminated work clothing must not be allowed out of the workplace. Wear eye protection/face protection. Wear protective gloves.
Response
If on skin Wash with plenty of water. If in eyes Rinse cautiously with water for several minutes Remove contact lenses, if present and easy to do. Continue rinsing. If skin irritation or rash occurs Get medical advice/attention. If eye irritation persists Get medical advice/attention. Take off contaminated clothing and wash it before reuse.
Storage
Store away from incompatible materials.
Disposal
Dispose of contents/container in accordance with local/regional/national/international regulations. Hazard(s) not otherwise None known.
Additional information
1% of the mixture consists of component(s) of unknown acute oral toxicity. 2.5% of the mixture consists of component(s) of unknown acute dermal toxicity. 3.39% of the mixture consists of component(s) of unknown acute inhalation toxicity. Use in manufacturing processes only.
