PS‐2L/KK 355 Remover

Hazard statements (CLP)

H335

Code

Statements

H335

May cause respiratory irritation

2.1 Classification of the substance or mixture

Serious eye damage (Category 1) Skin corrosion (Category 1A) Specific target organ toxicity ‐ repeated exposure Inhalation (Category 2) Central nervous system Specific target organ toxicity ‐ repeated exposure Oral (Category 2) Liver, Blood Specific target organ toxicity ‐ single exposure (Category 3) Respiratory system Central nervous system H335 Carcinogenicity (Category 1B) Germ cell mutagenicity (Category 1B) Reproductive toxicity (Category 2)

Hazard pictograms

Signalword Danger HazardStatement Causes serious eye damage. Causes severe skin burns and eye damage. May cause damage to organs through prolonged or repeated exposure. May cause respiratory irritation. May cause drowsiness or dizziness. May cause cancer. May cause genetic defects. Suspected of damaging fertility or the unborn child. Precautionary Do not breathe mist/vapors/spray. Do not handle until all safety precautions have been read and understood. Keep container tightly closed. Obtain special instructions before use. Use only non‐sparking tools. Use only outdoors or in Page 1 a well‐ventilated area. Wash thoroughly after handling. Wear protective gloves/ protective clothing/ eye protection/face protection. Get medical advice/ attention if you feel unwell. If exposed or concerned: Get medical advice/ attention. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If inhaled Remove person to fresh air and keep comfortable for breathing. If on skin (or hair) Take off immediately all contaminated clothing and wash before use. Rinse skin with water shower. If swallowed: Rinse mouth. Do NOT induce vomiting. Immediately call a poison center/doctor. Store in a well‐ventilated place. Keep cool. Store locked up. Keep container tightly closed. Dispose of contents/ container in accordance with local/ regional/ national/ international regulations.

2.3 Other hazards

Methylene Chloride has no flash point in a conventional closed tester, but it forms flammable vapor‐air mixtures at approximately 100C (212F), or higher. Product forms flammable vapor‐air mixtures. Lower temperature increases the difficulty of getting it to ignite; will release invisible vapors that form flammable mixtures that might ignite or explode. Vapors can travel considerable distances to an ignition source. Toxic gasses will form upon combustion. Material can accumulate static charges which can cause an incendiary electrical discharge. Material will partially emulsify and sink in water. It has a low boiling point of 40C (104F).