Newtech Repairer

Hazard statements (CLP)

H226, H315, H320, H332, H335, H351, H373

Code

Statements

H226

Flammable liquid and vapour

SECTION 2: Hazards identification

Hazard statements

This product is classified as: Xn, Harmful. Xi, Irritating. F, Flammable. Hazardous according to the criteria of SWA. Dangerous according to Australian Dangerous Goods (ADG) Code, IATA and IMDG/IMSBC criteria. H226: Flammable liquid and vapour. H315: Causes skin irritation. H320: Causes eye irritation. H332: Harmful if inhaled. H335: May cause respiratory irritation. H351: Suspected of causing cancer. H373: May cause damage to organs through prolonged or repeated exposure.

SUSMP Classification

S5

ADG classification

Class 3.1C: Flammable liquids.

UN Number

3269, POLYESTER RESIN KIT EPA New Zealand Approval Code: HSR 001221, Flammable Liquids, Medium Hazards

HSNO Classifications

3.1C, Flashpoint between 23oC and 65oC

Signal word

WARNING Flammable liquids Category 3 Skin Corrosion /Irritation Category 2 Serious eye damage/eye irritation Category 2B Acute Toxicity Inhalation Category 4 Specific Target Organ Toxicity - Single Exposure Category 3 Carcinogenicity Category 2 Specific Target Organ toxicity - repeated exposure Category 2

Prevention

P102: Keep out of reach of children. P201: Obtain special instructions before use. P202: Do not handle until all safety precautions have been read and understood. P210: Keep away from heat, sparks, open flames and hot surfaces. - No smoking. P233: Keep container tightly closed. P261: Avoid breathing vapours. P262: Do not get in eyes, on skin, or on clothing. P264: Wash contacted areas thoroughly after handling. P271: Use only outdoors or in a well ventilated area. P280: Wear protective gloves, protective clothing and eye or face protection

Response

P314: Get medical advice or attention if you feel unwell. P362: Take off contaminated clothing and wash before reuse. P301+P330+P331: IF SWALLOWED: Rinse mouth. Do NOT induce vomiting. P302+P352: IF ON SKIN: Wash with plenty of soap and water. P304+P340: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing. P305+P351+P338: IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P332+P313: If skin irritation occurs: Get medical advice. P337+P313: If eye irritation persists: Get medical advice. P370+P378: In case of fire, use carbon dioxide, dry chemical, foam, water fog. Alcohol resistant foam is the preferred firefighting medium but, if it is not available, fine water spray can be used.

Storage

P405: Store locked up. P402+P404: Store in a dry place. Store in a closed container. P411+P235: Store at temperatures not exceeding 30°C. Keep cool.

Disposal

P501: If they can not be recycled, dispose of contents to an approved waste disposal plant and containers to landfill (see Section 13 of this SDS). Emergency Overview Physical Description & Colour: Silver/Grey coloured paste. Odour: Characteristic styrene odour.

Health hazards

Acute exposure to styrene in humans results in respiratory effects, such as mucous membrane irritation, eye irritation, and gastrointestinal effects. Styrene vapour causes mild irritation of the nose and throat at concentrations around 100 ppm, definite irritation at 350-500 ppm and severe irritation at about 500 ppm. Symptoms such as headache, dizziness and fatigue (similar in some ways to drunkenness) are reported at concentrations above 100-200 ppm. Other symptoms such as slower reaction times, reduced manual dexterity, and impaired co-ordination and balance can be observed at concentrations above 200 ppm. Styrene liquid can cause mild to severe irritation of the eyes if splashing occurs. Styrene liquid defats the skin and can cause dermatitis. Limited evidence of a carcinogenic effect, irritating to eyes, respiratory system and skin, irritating to respiratory system and skin.