Note: Ingredients listed on restricted chemical lists
EC/CAS
1333-86-4
Name of the chemical
carbon black
Concentration
N/A
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
100-42-5
Name of the chemical
Styrene ( Vinyl benzene )
Concentration
N/A
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
General Information
Revision date
2020-10-05
Product name
ABS Plus Pipe
Chemical name
Not Applicable. Formulation, see Section 3
1.2.1 Relevant identified uses
Drain, waste and vent pipe
supplier name
Charlotte Pipe and Foundry Company (Plastics Division)
Emergency telephone
+1-704-372-3650
Icons in SDS
Company Information
company name
Charlotte Pipe and Foundry Company (Plastics Division)
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
GHS Status This material is hazardous in accordance with the hazard communication standard, 29 CFR 1910.1200. This product has not been tested as a whole. Hazards described on this SDS are based on the component ingredients. Toxic to Reproduction – Category 1
2.1 Classification of the substance or mixture
Carcinogenicity – Category 2 Specific Target Organ Toxicity (lungs, thymus) – Category 2 Germ Cell Mutagenicity – Category 2 Skin Sensitization – Category 1 Skin Irritation – Category 2
Hazard pictograms
Health hazard, exclamation point.
Signal word
Danger
Hazard statements
May damage fertility or the unborn child. May cause damage to organs (lungs, thymus) through prolonged or repeated exposure. May cause an allergic skin reaction Suspected of causing genetic defects (inhalation) Causes skin irritation. Suspected of causing cancer if inhaled.
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Do not breathe dust/fumes. Wear protective breathing gear, such as an N95 or P95 respirator. Wear protective gloves. If pipe is heated, wear heat resistant gloves. Contaminated clothing must not be allowed out of the workplace.
Response
If exposed or concerned Get medical advice/attention. If on skin wash with plenty of water Wash thoroughly with plenty of water after handling. If skin irritation or rash occurs: Get medical advice/attention. Specific treatment: wash with mild soap and water. Take off contaminated clothing and wash it before reuse.
Storage
Store locked up.
Disposal
Dispose of in accordance with local regulations.
2.3 Other hazards
None known.
Principle Routes of Exposure
Inhalation, skin. Exposure via these routes are anticipated primarily via fumes if the product is melted, particulates if the product is cut. Inhalation Melted product is flammable and produces intense heat and dense smoke during burning. Irritating gases and fumes may be given off during burning or thermal decomposition. Inhalation of airborne unbound particles of respirable size may cause cancer. Skin contact May cause allergic reaction. Eye contact No data available. Ingestion No data available.
