Note: Ingredients listed on restricted chemical lists
EC/CAS
123-86-4
Name of the chemical
acetic acid, butyl ester
Concentration
N/A
EC/CAS
1317-33-5
Name of the chemical
molybdenum disulphide
Concentration
N/A
General Information
Revision date
2020-11-19
Product name
Dry Film Lubricant
supplier name
Chance Company
Icons in SDS
Company Information
company name
Chance Company
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H222, H229, H304, H316, H336, H410
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
Section 2
SECTION 2: Hazards identification
29 CFR 1910.1200) OSHA/HCS Status: This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200)
2.1 Classification of the substance or mixture
Health Environmental Physical • SKIN CORROSION/IRRITATION - • CHRONIC AQUATIC TOXICANT - • FLAMMABLE AEROSOLS - Category 2 Category 1 • SPECIFIC TARGET ORGAN • GASES UNDER PRESSURE TOXICITY (SINGLE EXPOSURE)- - Compressed gas Category 3 • ASPIRATION TOXICITY - Category 1
Signal word
Danger
Precautionary statements
H222: Extremely flammable aerosol. • P201: Obtain special instructions before use • H229 Pressurized container May burst if heated • P202: Do not handle until all safety precautions have • H304: May be fatal if swallowed and enters airways been read and understood • H316: Causes mild skin irritation • P210: Keep away from heat/sparks/open flames/hot • H336: May cause drowsiness or dizziness surfaces – No smoking • H410: Very toxic to aquatic life with long lasting effects • P211: Do not spray on an open flame or other ignition source • P251 Pressurized container Do not pierce or burn, even after use • P261:Avoid breathing dust/fume/gas/mist/vapors/spray. • P264: Wash skin thoroughly after handling • P270: Do not eat, drink or smoke when using this product • P271: Use only outdoors or in a well-ventilated area • P280: Wear protective gloves and eye / face protection • P304 + P340 IF INHALED Remove victim to fresh air and keep at rest in a position comfortable for breathing • P305 + P351 + P338 IF IN EYES Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do so. Continue rinsing • P312: Call a POISON CENTER or doctor/ physician if you feel unwell • P332 + P313 If skin irritation occurs Get medical advice/ attention • P337 + P313 If eye irritation persists Get medical advice/attention • P410 + P412: Protect from sunlight. Do not expose to temperatures exceeding 50 °C/122 °F • P405: Store locked up • P501: Dispose of contents/container to an approved waste disposal plant
Additional information
Vapors may travel considerable distances to ignition sources and flash back. Hazardous gases can be produced requiring respirator. Heating above 500°F (260°C) may cause formation of potentially toxic substances. Prolonged exposure may cause chronic effects. May be irritating to eyes, respiratory system and skin. Prolonged skin contact may defat skin and produce dermatitis. May cause central nervous system depression with nausea, headache, dizziness, vomiting, and incoordination. Aspiration into lungs can produce severe lung damage. Do not smoke. Do not contaminate tobacco products. The thermal decomposition vapours of fluorinated polymers may cause polymer fume fever with flu-like symptoms in humans, especially when smoking contaminated tobacco. Intentional misuse by deliberately concentrating and inhaling contents may be harmful or fatal Do not puncture or burn aerosol can, even after use. When operating continuously for long periods, the aerosol container can become very cold. Care should be taken to avoid skin burns
2.3 Other hazards
None known