Elite Amplify

Hazard statements (CLP)

H320

Code

Statements

H320

Causes eye irritation

SECTION 2: Hazards identification

Physical hazards

Not classified

Health hazards

Serious eye damage/eye irritation Category 2B

Environmental hazards

Not classified

Hazard pictograms

None.

Signal word

Warning

Hazard statements

Causes eye irritation.

Prevention

Wash thoroughly after handling.

Response

If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.

Storage

Store in a well-ventilated place. Keep container tightly closed.

Disposal

Dispose of contents/container in accordance with local/regional/national/international regulations. Hazard(s) not otherwise None known. classified (HNOC)

Additional information

None.

2.1 Classification of the substance or mixture

Not classified. Health hazards Serious eye damage/eye irritation Category 2B Environmental hazards Not classified. OSHA defined hazards Not classified. Label elements Hazard symbol None. Signal word Warning Hazard statement Causes eye irritation. Precautionary statement Prevention Wash thoroughly after handling. Response If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Storage Store in a well-ventilated place. Keep container tightly closed. Disposal Dispose of contents/container in accordance with local/regional/national/international regulations. Hazard(s) not otherwise None known. classified (HNOC) Supplemental information None. 3. Composition/information on ingredients Mixtures Chemical name Common name and synonyms CAS number % Alkyl Polyglucoside C8-C10 68515-73-1 1 - < 3* Other components below reportable levels 90 - 100 4. First-aid measures Inhalation Move to fresh air. Call a physician if symptoms develop or persist. Skin contact Wash off with soap and water. Get medical attention if irritation develops and persists. Eye contact Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention. Ingestion Rinse mouth. Get medical attention if symptoms occur. Most important Irritation of eyes. Exposed individuals may experience eye tearing, redness, and discomfort. symptoms/effects, acute and delayed Indication of immediate Provide general supportive measures and treat symptomatically. Keep victim under observation. medical attention and special Symptoms may be delayed. treatment needed General information Ensure that medical personnel are aware of the material(s) involved, and take precautions to protect themselves. 5. Fire-fighting measures Suitable extinguishing media Water fog. Foam. Dry chemical powder. Carbon dioxide (CO2). Unsuitable extinguishing Do not use water jet as an extinguisher, as this will spread the fire. media Specific hazards arising from During fire, gases hazardous to health may be formed. the chemical Special protective equipment Self-contained breathing apparatus and full protective clothing must be worn in case of fire. and precautions for firefighters Fire fighting Move containers from fire area if you can do so without risk. equipment/instructions Specific methods Use standard firefighting procedures and consider the hazards of other involved materials. General fire hazards No unusual fire or explosion hazards noted. 6. Accidental release measures Personal precautions, Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Wear protective equipment and appropriate protective equipment and clothing during clean-up. Do not touch damaged containers emergency procedures or spilled material unless wearing appropriate protective clothing. Ensure adequate ventilation. Local authorities should be advised if significant spillages cannot be contained. For personal protection, see section 8 of the SDS. Methods and materials for Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is containment and cleaning up possible. Absorb in vermiculite, dry sand or earth and place into containers. Following product recovery, flush area with water. Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to remove residual contamination. Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS. Environmental precautions Avoid discharge into drains, water courses or onto the ground. 7. Handling and storage Precautions for safe handling Avoid contact with eyes. Provide adequate ventilation. Wear appropriate personal protective equipment. Observe good industrial hygiene practices. Conditions for safe storage, Store in tightly closed container. Store away from incompatible materials (see Section 10 of the including any incompatibilities SDS). 8. Exposure controls/personal protection Occupational exposure limits This mixture has no ingredients that have PEL, TLV, or other recommended exposure limit. Biological limit values No biological exposure limits noted for the ingredient(s). Appropriate engineering Good general ventilation should be used. Ventilation rates should be matched to conditions. If controls applicable, use process enclosures, local exhaust ventilation, or other engineering controls to maintain airborne levels below recommended exposure limits. If exposure limits have not been established, maintain airborne levels to an acceptable level. Provide eyewash station. Individual protection measures, such as personal protective equipment Eye/face protection Wear safety glasses with side shields (or goggles). Skin protection Hand protection Wear appropriate chemical resistant gloves. Other Wear suitable protective clothing. Respiratory protection In case of insufficient ventilation, wear suitable respiratory equipment. Thermal hazards Wear appropriate thermal protective clothing, when necessary. General hygiene Always observe good personal hygiene measures, such as washing after handling the material considerations and before eating, drinking, and/or smoking. Routinely wash work clothing and protective equipment to remove contaminants. 9. Physical and chemical properties Appearance Liquid. Physical state Liquid. Form Liquid. Color Amber Odor Not available. Odor threshold Not available. pH Not available. Melting point/freezing point 455 °F (235 °C) estimated Initial boiling point and boiling 211.95 °F (99.97 °C) estimated range Flash point Not available. Evaporation rate Not available. Flammability (solid, gas) Not applicable. Upper/lower flammability or explosive limits Explosive limit - lower (%) Not available. Explosive limit - upper (%) Not available. Vapor pressure -0.0007 hPa estimated Vapor density Not available. Relative density 1.19 g/cm³ Solubility(ies) Solubility (water) Not available. Partition coefficient Not available. (n-octanol/water) Auto-ignition temperature Not available. Decomposition temperature Not available. Viscosity Not available. Other information Density 1.00 g/cm3 estimated Explosive properties Not explosive. Oxidizing properties Not oxidizing. Percent volatile 63.66 % estimated Pounds per gallon 9.93 lb/gal Specific gravity 1 estimated 10. Stability and reactivity Reactivity The product is stable and non-reactive under normal conditions of use, storage and transport. Chemical stability Material is stable under normal conditions. Possibility of hazardous No dangerous reaction known under conditions of normal use. reactions Conditions to avoid Contact with incompatible materials. Incompatible materials Strong oxidizing agents. Hazardous decomposition No hazardous decomposition products are known. products 11. Toxicological information