Note: Ingredients listed on restricted chemical lists
EC/CAS
68475-59-2
Name of the chemical
Petroleum, coal, tar and natural gas and their derivatives generated using distillation and/or other processing methods if they contain ≥ 0,1 % w/w 1,3-butadiene Alkanes, C3-4, if they contain > 0,1 % w/w Butadiene
Concentration
10-30
EC/CAS
64742-49-0
Name of the chemical
Naphtha (petroleum), hydrotreated light
Concentration
30-50
EC/CAS
110-54-3
Name of the chemical
n-Hexan (790/2009)
Concentration
<2
General Information
Revision date
2025-07-11
Product name
INOX MX8 Aerosol
1.2.1 Relevant identified uses
Spray lubricant for industrial use
Icons in SDS
Company Information
company name
Candan Industries Pty. Ltd
GHS Information
Signal word
DANGER
Hazard Codes
Hazard statements (CLP)
H222, H229, H304, H315
Hazard statements
Code
Statements
H222
Extremely flammable aerosol
Section 2
SECTION 2: Hazards identification
Hazard statements
This product is classified as: Hazardous according to the criteria of SWA. Dangerous according to Australian Dangerous Goods (ADG) Code, IATA and IMDG/IMSBC criteria. H222: Extremely flammable aerosol H229 Pressurised container may burst if heated H304: May be fatal if swallowed and enters airways. H315: Causes skin irritation. (New Zealand) Aerosols Flammable Group Standard 2020 HSR002515
SUSMP Classification
None allocated
ADG classification
2 Classified as a Dangerous Good for transport in accordance with the Land Transport Rule Dangerous Goods 2005 and NZS 5433:2007. Emergency Overview Physical Description & Colour: Coarse jet of mobile red liquid setting to grease Odour: Hydrocarbon odour
UN Number
1950, AEROSOLS
Signal word
DANGER Flammable aerosols Category 1
Aspiration hazard
Category 1 Skin Corrosion /Irritation Category 2
Prevention
P210: Keep away from heat, sparks, open flames and hot surfaces. - No smoking. P211: Do not spray on an open flame or other ignition source. P233: Keep container tightly closed. P240: Ground/bond container and receiving equipment. P241: Use explosion-proof electrical ventilating, lighting and other equipment. P242: Use only non-sparking tools. P243: Take precautionary measures against static discharge. P251: Do not pierce or burn, even after use. P261: Avoid breathing fumes, mists, vapours or spray. P262: Do not get in eyes, on skin, or on clothing. P264: Wash contacted areas thoroughly after handling. P280: Wear protective gloves, protective clothing and eye or face protection.
Response
P362: Take off contaminated clothing and wash before reuse. P301+P310 IF SWALLOWED Immediately call a POISON CENTRE or doctor P301+P330+P331 IF SWALLOWED Rinse mouth. Do NOT induce vomiting P303+P361+P353 IF ON SKIN (or hair) Remove immediately all contaminated clothing. Rinse skin with water P332+P313 If skin irritation occurs Get medical advice P372: Explosion risk in case of fire. P381: Eliminate all ignition sources if safe to do so. P370+P378: In case of fire, use carbon dioxide, dry chemical, foam, water fog. Water fog or fine spray is the preferred medium for large fires.
Storage
P403: Store in a well-ventilated place. P405: Store locked up. P410+P412: Store below 30°C, protect from direct sunlight and do not expose to temperatures exceeding 50°C.
Disposal
P501: If they can not be recycled, dispose of contents to an approved waste disposal plant and containers to landfill (see Section 13 of this SDS).
Health hazards
skin irritant, if aspirated, may cause lung damage
