Note: Ingredients listed on restricted chemical lists
EC/CAS
409-21-2
Name of the chemical
Silicon carbide
Concentration
0-95
EC/CAS
7773-01-5
Name of the chemical
manganese chloride
Concentration
1-10
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
0-5
EC/CAS
1333-86-4
Name of the chemical
carbon black
Concentration
0-5
EC/CAS
1305-78-8
Name of the chemical
Calcium oxide
Concentration
0-5
General Information
Revision date
2019-12-03
Product name
Abrasive Blades - Rubber Resin Bond I
Product Synonyms
None
1.2.1 Relevant identified uses
Laboratory Use Only
Manufacturer Name
Buehler
Emergency telephone
+1 760 476 3962, +1 760 476 3960, +1 760 476 3959, +1 760 476 3961
Icons in SDS
Company Information
company name
Buehler
e-mail address of the competent person responsible for the Safety Data Sheet
custserv@buehler.com
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
Classification The hazard identification is based on a formalistic procedure as the hazard statements of the ingredients are summarized in This does not correspond to the hazardousness of the product itself A greater hazard, in most cases, is the exposure to the dust/fumes from the material or paint/coatings being ground. Most of the dust generated during grinding is from the base material being ground and the potential hazard from this exposure must be evaluated. This dust may present a fire or dust explosion hazard and may present a serious health hazard Carcinogenicity Category 2 Specific target organ toxicity (single exposure) Category 3 Specific target organ toxicity (repeated exposure) Category 1
Signal word
Danger
Hazard statements
May cause respiratory irritation Suspected of causing cancer Causes damage to organs through prolonged or repeated exposure . Appearance Dark Physical state Solid Odor No data available
Prevention
Obtain special instructions before use Do not handle until all safety precautions have been read and understood Do not breathe dusts or mists Wash hands thoroughly after handling Do not eat, drink or smoke when using this product Use personal protective equipment as required
Response
IF exposed or concerned: Get medical advice/attention Inhalation If experiencing respiratory symptoms: Call a POISON CENTER or doctor/physician IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing
Storage
None
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
2.3 Other hazards
Not applicable
Further information
No information available
Interactions with other chemicals
No information available.
2.1 Classification of the substance or mixture
The hazard identification is based on a formalistic procedure as the hazard statements of the ingredients are summarized in section 3. This does not correspond to the hazardousness of the product itself. A greater hazard, in most cases, is the exposure to the dust/fumes from the material or paint/coatings being ground. Most of the dust generated during grinding is from the base material being ground and the potential hazard from this exposure must be evaluated. This dust may present a fire or dust explosion hazard and may present a serious health hazard. Carcinogenicity Category 2 Specific target organ toxicity (single exposure) Category 3 Specific target organ toxicity (repeated exposure) Category 1
