Briggs 7 & Stratton Advanced Fuel Treatment & Stabilizer

Hazard statements (CLP)

H227, H305, H316, H317, H360, H401, H411

Code

Statements

H227

Combustible liquid

Appearance/Odor

Clear, Red Solvent

2.1 Classification of the substance or mixture

Skin corrosion / irritation category 3 Sensitization - skin category 1 Aspiration toxicant category 2 Reproductive toxicant category 1 Hazardous to the aquatic environment (acute hazard) category 2 Hazardous to the aquatic environment (chronic hazard) category 2 Flammable liquid category 4 Target Organs Not applicable.

Hazard pictograms

} 2 9

Signal word

DANGER

Hazard statements

H227 - Combustible liquid H305 - May be harmful if swallowed and enters airways H316 - Causes mild skin irritation H317 - May cause an allergic skin reaction H360 - May damage fertility or the unborn child H401 - Toxic to aquatic life H411 - Toxic to aquatic life with long lasting effects

2.3 Other hazards

Not determined.

Prevention

P210 - Keep away from heat/sparks/open flames/not surfaces — No smoking P261 - Avoid breathing dust/fume/gas/mist/vapours/spray P272 - Contaminated work clothing should not be allowed out of the workplace P273 - Avoid release to the environment P280 - Wear protective gloves/protective clothing/eye protection/face protection P285 - In case of inadequate ventilation wear respiratory protection Page 1 of 7

Response

P331 - Do NOT induce vomiting P363 - Wash contaminated clothing before reuse P391 - Collect spillage P301+P310 - IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician P302+P352 - IF ON SKIN: Wash with soap and water P333+P313 - If skin irritation or a rash occurs: Get medical advice/attention P370+P378 - In case of fire: Use dry chemical for extinction

Storage

Procedures P405 - Store locked up P403+P235 - Store in a well ventilated place. Keep cool

Disposal

P501 - Dispose of contents and container in accordance with federal, state, and local regulations Other: See section 11 for complete health hazard information. Component CAS Number Percentage (by weight) Distillates (petroleum), hydrotreated light 64742-47-8 85 -95% Cresol 1319-77-3 5.0 - 10% Butylated Hydroxytoluene 128-37-0 0.1 - 1.0% Mixture of isomers of trimethyloenzene 25551-13-7 0.1 - 1.0% Polyolefin alkyl phenol alkyl amine Proprietary 0.1 - 1.0% Methanol 67-56-1 0.1 - 1.0% Xylene 1330-20-7 <0.1% Ethylbenzene 100-41 -4 < 0.1% n-propylbenzene 103-65-1 <0.1% 2-ethyl hexanol 104-76-7 < 0.1% Cumene 98-82-8 < 0.1% The balance of components do not contribute to the overall classification of the fluid, according to the GHS Standard. FIRST AID MEASURES Eye Contact If irritation occurs, cautiously rinse eyes with lukewarm, gently flowing water for 5 minutes, while holding the eyelids open. If eye irritation persists: Get medical advice/attention. Skin Contact Avoid direct contact. Wear chemical protective clothing, if necessary. Take off contaminated clothing, shoes and leather goods (e.g. watchbands, belts). Wash skin with lukewarm, gently flowing water and mild soap until product is removed. Call a doctor if you feel unwell. If skin irritation or rash occurs: Get medical advice/attention. Discard contaminated clothing. Store contaminated clothing under water and wash before re-use or discard. Inhalation Remove source of exposure or move person to fresh air and keep comfortable for breathing. If experiencing respiratory symptoms: Call a doctor. If breathing is difficult, trained personnel should administer emergency oxygen if advised to do so by the doctor Ingestion If you feel unwell or concerned: Get medical advice/attention. Rinse mouth. Do NOT induce vomiting. If vomiting occurs naturally, lie on your side, in the recovery position. Other If exposed or concerned: Get medical advice/attention (carcinogen).Eliminate all ignition sources if safe to do so. Page 2 of 7 FIRE FIGHTING MEASURES Flash Point Flammable limits Extinguishing media 70T by Cleveland Open Cup Tester. Not determined. Use dry chemical, alcohol foam, all purpose AFFF or carbon dioxide to extinguish fire. Special firefighting procedures DO NOT direct a solid stream of water or foam into hot, burning pools of liquid since this may cause frothing and increase fire intensity. Frothing can be violent and possibly endanger any firefighter standing too close to the burning liquid. Use water spray to cool fire exposed containers and structures until fire is out if it can be done with minimal risk. Avoid spreading burning material with water used for cooling purposes. Wear full firefighting turn-out gear (full Bunker gear), and respiratory protection (SCBA). Unusual fire & explosion hazards Dense smoke may be generated while burning. Toxic fumes, gases or vapors may evolve on burning. High temperatures may create heavy flammable vapors that may settle along ground level and low spots to create an invisible fire hazard. Byproducts of combustion Fires involving this product may release oxides of carbon, phosphorus, nitrogen and sulfur; reactive hydrocarbons and irritating vapors. Autoignition temperature Explosion data Other Not determined. Not determined. Care should always be exercised in dust/mist areas. Dispose of fire debris and contaminated extinguishing water in accordance with official regulations. ACCIDENTAL RELEASE MEASURES Spill control procedures (land) Immediately turn off or isolate any source of ignition (pilot lights, electrical equipment, flames, heaters, etc.). Evacuate area and ventilate. Personnel wearing proper protective equipment should contain spill immediately with inert materials (sand, earth, chemical spill pads of cotton) by forming dikes. Dikes should be placed to contain spill in a manner that will prevent material from entering sewers and waterways. Cover spill with the fire- fighting material prescribed in Section 5. Large spill, once contained, may be picked up using explosion proof, non-sparking vacuum pumps, shovels, or buckets, and disposed of in suitable containers for disposal. Clean up residue with an appropriate solvent. If a large spill occurs notify appropriate authorities. In case of road spill or accident contact Chem-Trec (800-424-9300). Spill control procedures (water) Try to contain large spills with floating booms to prevent spill from spreading. Remove from surface by skimming or with suitable adsorbents. If a large spill occurs notify appropriate authorities (normally the National Response Center or Coast Guard at 800- 424-8802). Waste disposal method Do not empty into drains. All disposals must comply with federal, state, and local regulations. The material, if spilled or discarded may be a regulated waste. Refer to state and local regulations. Department of Transportation (DOT) regulations may apply for transporting this material when spilled. See Section 14. Other CAUTION - If spilled material is cleaned up using a regulated solvent, the resulting waste mixture will be regulated. HANDLING AND STORAGE Handling procedures Keep containers closed when not in use. Do not transfer to unmarked containers. Empty containers retain product residue which may exhibit hazards of material, therefore do not pressurize, cut, glaze, weld, or use for any other purposes. Return drums to reclamation centers for proper cleaning and reuse. Handling temperatures should not exceed 60° (140F) to min imize danger of burns. Open containers carefully in a well ventilated area or use appropriate respiratory protection. Wash thoroughly after handling. Page 3 of 7 Storage procedures Store containers away from heat, sparks, open flame, or oxidizing materials. Extended storage at excessive temperatures may produce odorous and toxic fumes from product decomposition. Additional information: No additional information. EXPOSURE CONTROLS / PERSONAL PROTECTION Exposure limits/standards for materials that can be formed when handling this product: OSHA TWA OSHASTEL ACGIH TWA *5 mg/m? *10 mg/m? Contains highly refined petroleum oil *5 mg/m? (PEL) (TLV) * Exposure limits not defined. Limits used are for, "oil mist”. TWA — Time Weighted Average is the employee’s average airborne exposure in any 8-hour work shift of a 40-hour work week which shall not be exceeded. STEL — Short Term Exposure Limit is the employee’s 15-minute time weighted average exposure which shall not be exceeded at any time during a work day unless another time limit is specified. All base oils, including additive carriers, contain <3.0% DMSO extractable material.