Note: Ingredients listed on restricted chemical lists
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
EC/CAS
84-74-2
Name of the chemical
Dibutyl phthalate
Concentration
N/A
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
General Information
Revision date
2015-10-09
Product name
ANTIVIBE DL-10 / DL-10 REGULAR / DL-10 REGULAR - SC / DL-10 HV
Product Synonyms
None
1.2.1 Relevant identified uses
Vibration damping
Icons in SDS
Company Information
company name
Blachford Corporation
GHS Information
Signal word
Danger
Section 2
2.1 Classification of the substance or mixture
OSHA Regulatory Status This product is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) due to the presence of small amounts of hazardous components. Carcinogenicity Category 1A Reproductive toxicity Category 1B Specific target organ toxicity (repeated exposure) Category 2
2.2 Label elements
Emergency Overview Danger
Hazard statements
May cause cancer if inhaled in high concentrations over prolonged and repeated periods of time May damage fertility or the unborn child if ingested in significant quantities May cause damage to lungs through prolonged or repeated inhalation.
Hazard pictograms
Health Hazard Appearance paste Physical state paste Odor Slight
Prevention
Obtain special instructions before use. Do not handle until all safety precautions have been read and understood. Use personal protective equipment as required. Do not breathe dust/mist/vapors/spray.
Response
IF exposed or concerned: Get medical advice.
2.3 Other hazards
Not applicable
Further information
This product is classified Carcinogen 1A due to the presence of silica at > 0.1%. Silica has been classified by IARC as a human carcinogen, however health effects are limited to inhalation of the fine fraction of crystalline silica. This product is an aqueous paste; exposure to the fine fraction of crystalline silica is not expected under normal use conditions. In the event the dried product is sanded, a potential to produce airborne fine fraction silica exists, and appropriate precautions (ventilation and respiratory protection) should be taken. Refer to Sections 7, 8 & 11 of this SDS for more information.