Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
EC/CAS
1314-13-2
Name of the chemical
Zinc oxide; C.I. 77947
Concentration
N/A
General Information
Revision date
2018-05-23
Product name
ULTRA SPEC EXTERIOR SOLID STAIN BASE 2
1.2.1 Relevant identified uses
Stain
Icons in SDS
Company Information
company name
Benjamin Moore & Co
GHS Information
Signal word
Danger
Section 2
2.1 Classification of the substance or mixture
This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) Carcinogenicity Category 1A Specific target organ toxicity (repeated exposure) Category 1
2.2 Label elements
Danger
Hazard statements
May cause cancer Causes damage to organs through prolonged or repeated exposure Appearance liquid Odor little or no odor
Prevention
Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Do not breathe dust/fume/gas/mist/vapors/spray Wash face, hands and any exposed skin thoroughly after handling Do not eat, drink or smoke when using this product
Response
IF exposed or concerned: Get medical advice/attention
Storage
Store locked up
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
2.3 Other hazards
Not applicable
Further information
No information available
