Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
123-86-4
Name of the chemical
acetic acid, butyl ester
Concentration
N/A
EC/CAS
108-10-1
Name of the chemical
4-methylpentan-2-one; isobutyl methyl ketone (MIBK)
Concentration
N/A
General Information
Revision date
2018-08-03
Product name
POLYESTER URETHANE DEEP BASE
Emergency telephone
800-424-9300
Icons in SDS
Company Information
company name
Benjamin Moore & Co
GHS Information
Signal word
Warning
Section 2
2.1 Classification of the substance or mixture
This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) Serious eye damage/eye irritation Category 2A Carcinogenicity Category 2 Specific target organ toxicity (repeated exposure) Category 2 Flammable liquids Category 3
2.2 Label elements
Warning
Hazard statements
Causes serious eye irritation Suspected of causing cancer May cause damage to organs through prolonged or repeated exposure Flammable liquid and vapor Appearance liquid Odor solvent
Prevention
Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Wash face, hands and any exposed skin thoroughly after handling Wear eye/face protection Do not breathe dust/fume/gas/mist/vapors/spray Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking Keep container tightly closed Ground/bond container and receiving equipment Use explosion-proof electrical/ventilating/lighting/equipment Use only non-sparking tools Take precautionary measures against static discharge
Response
IF exposed or concerned: Get medical advice/attention Eyes IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing If eye irritation persists: Get medical advice/attention Skin IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower Fire In case of fire: Use CO2, dry chemical, or foam for extinction
Storage
Store locked up Store in a well-ventilated place. Keep cool
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
2.3 Other hazards
Not applicable
Further information
No information available
Other hazards
IMPORTANT: Designed to be mixed with other components. Mixture will have hazards of all components. Before opening packages, read all warning labels. Follow all precautions. CAUTION: All floor coatings may become slippery when wet. Where non-skid characteristics are desired, use an appropriate anti-slip aggregate.
