Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
100-51-6
Name of the chemical
Benzyl Alcohol
Concentration
N/A
EC/CAS
64742-95-6
Name of the chemical
Solvent naphtha (petroleum), light arom
Concentration
N/A
EC/CAS
7631-86-9
Name of the chemical
Silver adsorbed on silicon dioxide
Concentration
N/A
EC/CAS
1333-86-4
Name of the chemical
carbon black
Concentration
N/A
EC/CAS
98-82-8
Name of the chemical
Cumol (2022/692)
Concentration
N/A
General Information
Revision date
2016-06-02
Product name
POLYAMIDE EPOXY SILVER GRAY
Manufacturer Name
Benjamin Moore & Co
Icons in SDS
Company Information
company name
Benjamin Moore & Co
GHS Information
Signal word
Danger
Section 2
2.1 Classification of the substance or mixture
This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2 Skin sensitization Category 1 Carcinogenicity Category 1B Specific target organ toxicity (repeated exposure) Category 2 Aspiration toxicity Category 1 Flammable liquids Category 3
2.2 Label elements
Danger
Hazard statements
Causes skin irritation Causes serious eye irritation May cause an allergic skin reaction May cause cancer May cause damage to organs through prolonged or repeated exposure May be fatal if swallowed and enters airways Flammable liquid and vapor Appearance liquid Odor little or no odor
Prevention
Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Wash face, hands and any exposed skin thoroughly after handling Contaminated work clothing should not be allowed out of the workplace Do not breathe dust/fume/mist/vapors/spray Keep away from heat/sparks/open flames/hot surfaces, no smoking Keep container tightly closed Ground/bond container and receiving equipment Use explosion-proof electrical/ventilating/lighting/equipment Use only non-sparking tools Take precautionary measures against static discharge Wear protective gloves/protective clothing/eye protection/face protection
Response
If exposed or concerned get medical attention Eyes If in eyes rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing If eye irritation persists get medical attention Skin If skin irritation or rash occurs get medical attention If on skin (or hair) take off immediately all contaminated clothing. Rinse skin with water Wash contaminated clothing before reuse Ingestion If swallowed immediately call a POISON CENTER or physician Do NOT induce vomiting Fire In case of fire use CO2, dry chemical, or foam for extinction
Storage
Store locked up Store in a well-ventilated place. Keep cool
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
2.3 Other hazards
Not Applicable
Further information
No information available
Other hazards
IMPORTANT: Designed to be mixed with other components. Mixture will have hazards of all components. Before opening packages, read all warning labels. Follow all precautions. CAUTION: All floor coatings may become slippery when wet. Where non-skid characteristics are desired, a small amount of clean sand may be added. Stir often during application.