Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
64742-95-6
Name of the chemical
Solvent naphtha (petroleum), light arom
Concentration
N/A
EC/CAS
96-29-7
Name of the chemical
2-Butanonoxim (2020/1182)
Concentration
N/A
General Information
Revision date
2016-06-14
Product name
RAPID DRY GLOSS COATING DEEP BASE
Manufacturer Name
Benjamin Moore & Co
Emergency telephone
Benjamin Moore & Co
Icons in SDS
Company Information
company name
Benjamin Moore & Co., Limited
GHS Information
Signal word
Danger
Section 2
2.1 Classification of the substance or mixture
This chemical is considered hazardous by the Hazardous Products Regulations (HPR: SOR/2015-17) Acute toxicity - Inhalation (Dusts/Mists) Category 4 Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 2 Skin sensitization Category 1 Carcinogenicity Category 2 Specific target organ toxicity (single exposure) Category 3 Specific target organ toxicity (repeated exposure) Category 2 Aspiration toxicity Category 1 Flammable liquids Category 3 Physical hazard not otherwise classified Category 1
2.2 Label elements
Danger
Hazard statements
Harmful if inhaled Causes skin irritation Causes serious eye irritation May cause an allergic skin reaction Suspected of causing cancer May cause respiratory irritation May cause damage to organs through prolonged or repeated exposure May be fatal if swallowed and enters airways Flammable liquid and vapor Risk of spontaneous combustion Appearance liquid Odor solvent
Prevention
Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Use only outdoors or in a well-ventilated area Wash face, hands and any exposed skin thoroughly after handling Contaminated work clothing should not be allowed out of the workplace Do not breathe dust/fume/mist/vapors/spray Keep away from heat/sparks/open flames/hot surfaces, no smoking Keep container tightly closed Ground/bond container and receiving equipment Use explosion-proof electrical/ventilating/lighting/equipment Use only non-sparking tools Take precautionary measures against static discharge Keep cool Wear protective gloves/protective clothing/eye protection/face protection Immediately after use, place rags, steel wool or waste used with this product in a sealed water-filled metal container or lay flat to dry.
Response
If exposed or concerned get medical attention Eyes If in eyes rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing If eye irritation persists get medical attention Skin If skin irritation or rash occurs get medical attention If on skin (or hair) take off immediately all contaminated clothing. Rinse skin with water Wash contaminated clothing before reuse Inhalation If inhaled remove victim to fresh air and keep at rest in a position comfortable for breathing Ingestion If swallowed immediately call a POISON CENTER or physician Do NOT induce vomiting Fire In case of fire use CO2, dry chemical, or foam for extinction
Storage
Store locked up Store in a well-ventilated place. Keep container tightly closed
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant Materials such as rags used with this product may begin to burn by themselves. After use, put rags in water or lay flat to dry, then discard.
Further information
No information available