Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
7-13%
EC/CAS
111-76-2
Name of the chemical
Ethylene glycol monobutyl ether (EGBE)
Concentration
1-5%
EC/CAS
1333-86-4
Name of the chemical
carbon black
Concentration
0.1-0.25%
EC/CAS
7664-41-7
Name of the chemical
ammonia
Concentration
0.1-0.25%
General Information
Revision date
2016-06-21
Product name
QUICK DRY ACRYLIC SPRAY DTM FINISH LIGHT GRAY
1.2.1 Relevant identified uses
Paint
Manufacturer Name
Benjamin Moore & Co
Icons in SDS
Company Information
company name
Benjamin Moore & Co., Limited
Section 2
SECTION 2: Hazards identification
Classification This chemical is considered hazardous by the Hazardous Products Regulations (HPR: SOR/2015-17) Carcinogenicity Category 2 Label elements Warning Hazard statements Suspected of causing cancer _____________________________________________________________________________________________ Page 1 / 9 Appearance liquid Odor little or no odor Precautionary Statements - Prevention Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Precautionary Statements - Response If exposed or concerned get medical attention Precautionary Statements - Storage Store locked up
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
Further information
No information available
2.3 Other hazards
CAUTION: All floor coatings may become slippery when wet. Where non-skid characteristics are desired, a small amount of clean sand may be added. Stir often during application.
2.1 Classification of the substance or mixture
This chemical is considered hazardous by the Hazardous Products Regulations (HPR: SOR/2015-17) Carcinogenicity
