Note: Ingredients listed on restricted chemical lists
EC/CAS
8052-41-3
Name of the chemical
Stoddard Solvent; Naphtha (petroleum), hydrodesulfurized heavy
Concentration
5-10%
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
5-10%
EC/CAS
14807-96-6
Name of the chemical
Talc
Concentration
5-10%
EC/CAS
64742-89-8
Name of the chemical
Solvent naphtha (petroleum), light aliph
Concentration
3-7%
EC/CAS
64742-49-0
Name of the chemical
Naphtha (petroleum), hydrotreated light
Concentration
1-5%
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
0.5-1%
General Information
Revision date
2017-06-29
Product name
PRIME LOCK PLUS - WHITE
Manufacturer Name
Benjamin Moore & Co
Icons in SDS
Company Information
company name
Benjamin Moore & Co., Limited
GHS Information
Signal word
Danger
Section 2
2.1 Classification of the substance or mixture
This chemical is not considered hazardous by the Hazardous Products Regulations (HPR: SOR/2015-17) Germ cell mutagenicity Category 1B Carcinogenicity Category 1A Reproductive toxicity Category 2 Specific target organ toxicity (repeated exposure) Category 1 Aspiration toxicity Category 1 Flammable liquids Category 3 Physical hazard not otherwise classified Category 1
2.2 Label elements
Danger
Hazard statements
May cause genetic defects May cause cancer Suspected of damaging fertility or the unborn child Causes damage to organs through prolonged or repeated exposure May be fatal if swallowed and enters airways Flammable liquid and vapor Risk of spontaneous combustion Appearance liquid Odor solvent
Prevention
Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Do not breathe dust/fume/mist/vapors/spray Wash face, hands and any exposed skin thoroughly after handling Do not eat, drink or smoke when using this product Keep away from heat/sparks/open flames/hot surfaces, no smoking Keep container tightly closed Ground/bond container and receiving equipment Use explosion-proof electrical/ventilating/lighting/equipment Use only non-sparking tools Take precautionary measures against static discharge Immediately after use, place rags, steel wool or waste used with this product in a sealed water-filled metal container or lay flat to dry.
Response
If exposed or concerned get medical attention Skin If on skin (or hair) take off immediately all contaminated clothing. Rinse skin with water Ingestion If swallowed immediately call a POISON CENTER or physician Do NOT induce vomiting Fire In case of fire use CO2, dry chemical, or foam for extinction
Storage
Store locked up Store in a well-ventilated place. Keep cool
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant Materials such as rags used with this product may begin to burn by themselves. After use, put rags in water or lay flat to dry, then discard.
Further information
No information available