Note: Ingredients listed on restricted chemical lists
EC/CAS
37244-96-5
Name of the chemical
nepheline syenite
Concentration
7-13%
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
5-10%
EC/CAS
64742-89-8
Name of the chemical
Solvent naphtha (petroleum), light aliph
Concentration
3-7%
EC/CAS
8052-41-3
Name of the chemical
Stoddard Solvent; Naphtha (petroleum), hydrodesulfurized heavy
Concentration
1-5%
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
0.25-0.5%
General Information
Revision date
2021-04-20
Product name
FRESH START MULTI-PURPOSE OIL BASED PRIMER WHITE
1.2.1 Relevant identified uses
Primers
Manufacturer Name
Benjamin Moore & Co
Emergency telephone
+1 703-741-5970, 1-800-424-9300, +1 703-527-3887
Icons in SDS
Company Information
company name
Benjamin Moore & Co., Limited
Section 2
SECTION 2: Hazards identification
Classification This chemical is considered hazardous by the Hazardous Products Regulations (HPR: SOR/2015-17) Skin corrosion/irritation Category 2 Carcinogenicity Category 1A Specific target organ toxicity (repeated exposure) Category 1 Aspiration toxicity Category 1 Flammable liquids Category 3 Physical hazard not otherwise classified Category 1 Label elements Danger Hazard statements Causes skin irritation May cause cancer Causes damage to organs through prolonged or repeated exposure May be fatal if swallowed and enters airways Flammable liquid and vapor Risk of spontaneous combustion Appearance liquid Odor solvent Precautionary Statements - Prevention Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Wash face, hands and any exposed skin thoroughly after handling Do not breathe dust/fume/gas/mist/vapors/spray Do not eat, drink or smoke when using this product Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking Keep container tightly closed Ground/bond container and receiving equipment Use explosion-proof electrical/ventilating/lighting/equipment Use only non-sparking tools Take precautionary measures against static discharge Immediately after use, place rags, steel wool or waste used with this product in a sealed water-filled metal container or lay flat to dry Precautionary Statements - Response IF exposed or concerned: Get medical advice/attention Skin If skin irritation occurs: Get medical advice/attention IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower Wash contaminated clothing before reuse Ingestion IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician Do NOT induce vomiting Fire In case of fire: Use CO2, dry chemical, or foam for extinction Precautionary Statements - Storage Store locked up Store in a well-ventilated place. Keep cool
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant Materials such as rags used with this product may begin to burn by themselves. After use, put rags in water or lay flat to dry, then discard.
Further information
3.9 % of the mixture consists of ingredient(s) of unknown toxicity
2.1 Classification of the substance or mixture
This chemical is considered hazardous by the Hazardous Products Regulations (HPR: SOR/2015-17) Skin corrosion/irritation Category 2 Carcinogenicity Category 1A Specific target organ toxicity (repeated exposure) Category 1 Aspiration toxicity Category 1 Flammable liquids Category 3 Physical hazard not otherwise classified