Note: Ingredients listed on restricted chemical lists
EC/CAS
25068-38-6
Name of the chemical
4,4'-Isopropylidenediphenol, oligomeric reaction products with 1-chloro-2,3-epoxypropane
Concentration
N/A
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
EC/CAS
68609-97-2
Name of the chemical
Oxirane, mono[(C12-14-alkyloxy)methyl] derivs
Concentration
N/A
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
84852-15-3
Name of the chemical
Nonylphenol (NP), mixed isomers
Concentration
N/A
EC/CAS
1333-86-4
Name of the chemical
carbon black
Concentration
N/A
General Information
Revision date
2016-11-29
Product name
100% SOLIDS EPOXY FLOOR COATING SILVER GRAY
Manufacturer Name
Benjamin Moore & Co
Emergency telephone
Benjamin Moore & Co
Icons in SDS
Company Information
company name
Benjamin Moore & Co., Limited
GHS Information
Signal word
Danger
Section 2
2.1 Classification of the substance or mixture
This chemical is considered hazardous by the Hazardous Products Regulations (HPR: SOR/2015-17) Skin corrosion/irritation Category 2 Serious eye damage/eye irritation Category 1 Skin sensitization Category 1 Carcinogenicity Category 1A Reproductive toxicity Category 2 Specific target organ toxicity (repeated exposure) Category 1
2.2 Label elements
Danger
Hazard statements
Causes skin irritation Causes serious eye damage May cause an allergic skin reaction May cause cancer Suspected of damaging fertility or the unborn child Causes damage to organs through prolonged or repeated exposure Appearance liquid Odor little or no odor
Prevention
Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Wash face, hands and any exposed skin thoroughly after handling Contaminated work clothing should not be allowed out of the workplace Wear protective gloves Do not breathe dust/fume/mist/vapors/spray Do not eat, drink or smoke when using this product
Response
If exposed or concerned get medical attention Eyes If in eyes rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing Immediately call a POISON CENTER or physician Skin If on skin wash with plenty of soap and water Take off contaminated clothing and wash before reuse If skin irritation or rash occurs get medical attention
Storage
Store locked up
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
Further information
No information available
2.3 Other hazards
IMPORTANT: Designed to be mixed with other components. Mixture will have hazards of all components. Before opening packages, read all warning labels. Follow all precautions. CAUTION: All floor coatings may become slippery when wet. Where non-skid characteristics are desired, a small amount of clean sand may be added. Stir often during application.
