Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
10-15
EC/CAS
123-86-4
Name of the chemical
acetic acid, butyl ester
Concentration
10-15
EC/CAS
108-10-1
Name of the chemical
4-methylpentan-2-one; isobutyl methyl ketone (MIBK)
Concentration
1-5
EC/CAS
108-88-3
Name of the chemical
Toluene
Concentration
0.1-0.5
General Information
Revision date
2024-03-08
Product name
HP POLYESTER URETHANE GLOSS - DEEP BASE
1.2.1 Relevant identified uses
Paint
Manufacturer Name
Benjamin Moore & Co
Emergency telephone
+1 703-741-5970, 1-800-424-9300, +1 703-527-3887
Icons in SDS
Company Information
company name
Benjamin Moore & Co
Section 2
SECTION 2: Hazards identification
This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) Classification
Aspiration hazard
Category 1 Flammable liquids Category 3 Label elements Danger Hazard statements Causes serious eye irritation May cause genetic defects Suspected of causing cancer Suspected of damaging fertility or the unborn child May cause damage to organs through prolonged or repeated exposure May be fatal if swallowed and enters airways Flammable liquid and vapor Appearance liquid Odor solvent Precautionary Statements - Prevention Obtain special instructions before use Do not handle until all safety precautions have been read and understood Use personal protective equipment as required Wash face, hands and any exposed skin thoroughly after handling Wear eye/face protection Do not breathe dust/fume/gas/mist/vapors/spray Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking Keep container tightly closed Ground and bond container and receiving equipment Use only non-sparking tools Take action to prevent static discharges Precautionary Statements - Response IF exposed or concerned: Get medical advice/attention Eyes IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do Continue rinsing If eye irritation persists: Get medical advice/attention Skin IF ON SKIN (or hair): Remove/Take off immediately all contaminated clothing. Rinse skin with water/shower Ingestion IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician Do NOT induce vomiting Fire In case of fire: Use CO2, dry chemical, or foam for extinction Precautionary Statements - Storage Store locked up Store in a well-ventilated place. Keep cool
Precautionary statements
Disposal Dispose of contents/container to an approved waste disposal plant
2.3 Other hazards
Not applicable
Further information
No information available IMPORTANT: Designed to be mixed with other components. Mixture will have hazards of all components. Before opening packages, read all warning labels. Follow all precautions. CAUTION: All floor coatings may become slippery when wet. Where non-skid characteristics are desired, use an appropriate anti-slip aggregate.
2.1 Classification of the substance or mixture
This chemical is considered hazardous by the 2012 OSHA Hazard Communication Standard (29 CFR 1910.1200) Serious eye damage/eye irritation Category 2 Germ cell mutagenicity Category 1B Carcinogenicity Category 2 Reproductive toxicity Category 2 Specific target organ toxicity (repeated exposure) Category 2 Aspiration hazard Category 1 Flammable liquids