Information not relevant

Principle Routes of Exposure

Acute local Acute Chronic Acute local Acute Chronic systemic local systemic local systemic Oral. VND 11 mg/kg/d Inhalation. VND 32 VND 150 mg/m3 Skin. VND 11 VND 25 mg/kg/d Legend: (C) = CEILING ; INHAL = Inhalable Fraction ; RESP = Respirable Fraction ; THORA = Thoracic Fraction. VND = hazard identified but no DNEL/PNEC available ; NEA = no exposure expected ; NPI = no hazard identified. 8.2. Exposure controls. As the use of adequate technical equipment must always take priority over personal protective equipment, make sure that the workplace is well aired through effective local aspiration. HAND PROTECTION Protect hands with category III work gloves (see standard EN 374). SECTION 8. Exposure controls/personal protection. ... / >> The following should be considered when choosing work glove material: compatibility, degradation, failure time and permeability. The work gloves' resistance to chemical agents should be checked before use, as it can be unpredictable. The gloves' wear time depends on the duration and type of use. SKIN PROTECTION Wear category I professional long-sleeved overalls and safety footwear (see Directive 89/686/EEC and standard EN ISO 20344). Wash body with soap and water after removing protective clothing. EYE PROTECTION Wear airtight protective goggles (see standard EN 166). RESPIRATORY PROTECTION If the threshold value (e.g. TLV-TWA) is exceeded for the substance or one of the substances present in the product, use a mask with a type A filter whose class (1, 2 or 3) must be chosen according to the limit of use concentration. (see standard EN 14387). In the presence of gases or vapours of various kinds and/or gases or vapours containing particulate (aerosol sprays, fumes, mists, etc.) combined filters are required. Respiratory protection devices must be used if the technical measures adopted are not suitable for restricting the worker's exposure to the threshold values considered. The protection provided by masks is in any case limited. If the substance considered is odourless or its olfactory threshold is higher than the corresponding TLV-TWA and in the case of an emergency, wear open-circuit compressed air breathing apparatus (in compliance with standard EN 137) or external air-intake breathing apparatus (in compliance with standard EN 138). For a correct choice of respiratory protection device, see standard EN 529. ENVIRONMENTAL EXPOSURE CONTROLS. The emissions generated by manufacturing processes, including those generated by ventilation equipment, should be checked to ensure compliance with environmental standards. SECTION 9. Physical and chemical properties. 9.1. Information on basic physical and chemical properties. Appearance liquid Colour silver Odour mild Odour threshold. Not available. pH. 6,5 - 7,5 Melting point / freezing point. Not available. Initial boiling point. 100 °C. Boiling range. Not available. Flash point. > 60 °C. Evaporation Rate Not available. Flammability of solids and gases Not available. Lower inflammability limit. Not available. Upper inflammability limit. Not available. Lower explosive limit. Not available. Upper explosive limit. Not available. Vapour pressure. 23 hPa (20°C) Vapour density Not available. Relative density. 1 - 1,02 g/cm3 Solubility partially soluble in water Partition coefficient: n-octanol/water Not available. Auto-ignition temperature. Not available. Decomposition temperature. Not available. Viscosity ~ 40 sec (DIN 4 cup) Explosive properties Not available. Oxidising properties Not available.

Further information

VOC (Directive 2010/75/EC) : 10,40 % - 106,08 g/litre. VOC (volatile carbon) : 5,59 % - 57,06 g/litre. SECTION 10. Stability and reactivity. 10.1. Reactivity. 1-METHOXY-2-PROPANOL Dissolves various plastic materials.Stable in normal conditions of use and storage. Absorbs and disolves in water and in organic solvents. With air it may slowly form explosive peroxides. 10.2. Chemical stability. Information not available. 10.3. Possibility of hazardous reactions. The product may react violently with water. SECTION 10. Stability and reactivity. ... / >> 1-METHOXY-2-PROPANOL May react dangerously with: strong oxidising agents,strong acids. 10.4. Conditions to avoid. Avoid overheating. Prevent moisture or water from penetrating inside the containers. 1-METHOXY-2-PROPANOL Avoid exposure to: air. 10.5. Incompatible materials. 1-METHOXY-2-PROPANOL Incompatible with: oxidising substances,strong acids,alkaline metals. 10.6. Hazardous decomposition products. Information not available.