Note: Ingredients listed on restricted chemical lists
EC/CAS
7440-22-4
Name of the chemical
Silver
Concentration
N/A
EC/CAS
7440-50-8
Name of the chemical
Copper
Concentration
N/A
EC/CAS
231-131-3
Name of the chemical
Colloidal silver (nano) [INCI] (11)
Concentration
N/A
EC/CAS
231-116-1
Name of the chemical
Platinum (nano) [INCI] (11), Colloidal Platinum (nano) [INCI] (11) Acetyl tetrapeptide-17 Colloidal Platinum (nano) [INCI] (11)
Concentration
N/A
EC/CAS
231-159-6
Name of the chemical
Copper (nano) [INCI] (11), Colloidal Copper (nano) [INCI] (11)
Concentration
N/A
General Information
Revision date
2018-05-29
Product name
InLloyd 100
Product name
InLloyd 100
Identification on the label/Trade name
Gold base alloy (REF 61120)
1.2.1 Relevant identified uses
Manufacturing of dental prosthesis in a dental laboratory
Icons in SDS
Company Information
company name
BEGO Bremer Goldschlägerei
e-mail address of the competent person responsible for the Safety Data Sheet
msds@bego.com
GHS Information
Signal word
-
Section 2
Classifications
This product is assessed and classified using the methods and criteria below referred to in Article 9 of Regulation (EC) n° 1272/2008:
Physical hazards
determined through assessment data based on the methods or standards referred to in part 2 of Annex I to CLP
Health hazards
determined through toxicological and ecotoxicological assessment data based on the methods or standards referred to in Part 3, 4 and 5 of Annex I to CLP. This product does not meet the classification criteria given in the Regulation (EC) No 1272/2008 (CLP).
2.2 Label elements
Labelling according to Regulation (EC) No 1272/2008 (CLP Regulation)
Hazard statements
EUH210 Safety data sheet available on request.
Precautionary statements
Labelling information In the form in which it is marketed, the product causes no danger to health for humans through inhalation, swallowing or contact with the skin. There is therefore no obligation to label the product in accordance with: regulation 1272/2008 (CLP annex I; 1.3.4. "Metals in massive form, alloys, mixtures containing polymers, mixtures containing elastomers). The labelling (EU hazard statements) meets the criteria of annex II of Directive (EC) Nr. 1272/2008 (CLP).
2.3 Other hazards
If the product form in the as-supplied state is changed through further processing (e.g. through grinding, polishing, electrical discharge machining, welding or melting) and dust or vapours are produced, there may be danger from hazardous components in the product (see information in chapter 3). PBT assessment No data available. vPvB assessment No data available.
