Note: Ingredients listed on restricted chemical lists
EC/CAS
13463-67-7
Name of the chemical
Reaction mass of titanium dioxide and silver chloride
Concentration
N/A
EC/CAS
25068-38-6
Name of the chemical
4,4'-Isopropylidenediphenol, oligomeric reaction products with 1-chloro-2,3-epoxypropane
Concentration
N/A
EC/CAS
14807-96-6
Name of the chemical
Talc
Concentration
N/A
EC/CAS
21645-51-2
Name of the chemical
Aluminium hydroxide
Concentration
N/A
EC/CAS
7631-86-9
Name of the chemical
Silver adsorbed on silicon dioxide
Concentration
N/A
EC/CAS
14808-60-7
Name of the chemical
Silica, crystalline
Concentration
N/A
General Information
Revision date
2015-01-29
Product name
Duxone 1K High Build Etch Primer
1.2.1 Relevant identified uses
of the substance/preparation
supplier name
Axalta Coating Systems Australia Pty Limited
Icons in SDS
Company Information
company name
Axalta Coating Systems Australia Pty Limited
GHS Information
Signal word
Danger
Section 2
SECTION 2: Hazards identification
Classified as a Dangerous Good according to NZS 5433 Classified as hazardous according to criteria in the HS (Minimum Degrees of Hazard) Regulations 2001
HSNO Classifications
Flammable liquids Category 3.1B Skin corrosion/irritation Category 6.3A Serious eye damage/eye irritation Category 8.3A Skin sensitisation Category 6.5B Chronic aquatic toxicity Category 9.1C Endpoints which are “”not classified“”, “”cannot classified“” and “”not applicable“” are not shown
Signal word
Danger
Hazard statements
Highly flammable liquid and vapour. Causes skin irritation. Causes serious eye damage. May cause an allergic skin reaction. Harmful to aquatic life with long lasting effects.
Precautionary statements
Avoid release to the environment. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Keep container tightly closed. Wear protective gloves/protective clothing/eye protection/face protection. Avoid breathing dust/ vapours/ spray. IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If skin irritation or rash occurs: Get medical advice/ attention. Immediately call a POISON CENTER or doctor/ physician. Wash contaminated clothing before reuse. Store in a well-ventilated place. Keep cool.
Other hazards which do not result in classification
Contains epoxy constituents. See information supplied by the manufacturer.
