Note: Ingredients listed on restricted chemical lists
General Information
Revision date
2019-06-17
Product name
Speedisk Oil & Grease Standards Kit
CAS No.
67-64-1
1.2.2. Uses advised against
Not determined
Emergency telephone
01-800-681-9531
Icons in SDS
Company Information
company name
Avantor Performance Materials, LLC
e-mail address of the competent person responsible for the Safety Data Sheet
info@avantormaterials.com
GHS Information
Signal word
Danger
Hazard Codes
Hazard statements (CLP)
H225, H319
Hazard statements
Code
Statements
H225
Highly Flammable liquid and vapour
Section 2
Physical hazards
Flammable liquids Category 2
Health hazards
Serious Eye Damage/Eye Irritation Category 2A Specific Target Organ Toxicity - Category 3 Single Exposure
Signal word
Danger
Hazard statements
H225: Highly flammable liquid and vapor. H319: Causes serious eye irritation.
Prevention
P210: Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking. P240: Ground and bond container and receiving equipment. P241: Use explosion-proof [electrical/ventilating/lighting] equipment. P243: Take action to prevent static discharges. P280: Wear protective gloves/protective clothing/eye protection/face protection. P264: Wash hands thoroughly after handling. P261: Avoid breathing dust/fume/gas/mist/vapors/spray. P271: Use only outdoors or in a well-ventilated area.
Response
P303+P361+P353 IF ON SKIN (or hair) Take off immediately all contaminated clothing. Rinse skin with water [or shower]. P305+P351+P338 IF IN EYES Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P337+P313 If eye irritation persists Get medical advice/attention P304+P340 IF INHALED Remove person to fresh air and keep comfortable for breathing. P312: Call a POISON CENTER/doctor if you feel unwell.
Storage
P405: Store locked up. P403+P233: Store in a well-ventilated place. Keep container tightly closed.
Disposal
P501: Dispose of contents/container to an appropriate treatment and disposal facility in accordance with applicable laws and regulations, and product characteristics at time of disposal.
