Note: Ingredients listed on restricted chemical lists
EC/CAS
231-072-3/7429-90-5
Name of the chemical
Aluminium
Concentration
≥90
EC/CAS
231-175-3/7440-66-6
Name of the chemical
Zinc ()
Concentration
≤4,0
EC/CAS
231-105-1/7439-96-5
Name of the chemical
Manganese
Concentration
≤1,5
EC/CAS
231-159-6/7440-50-8
Name of the chemical
Copper
Concentration
≤1,4 029-019-
EC/CAS
231-157-5/7440-47-3
Name of the chemical
Chromium‡
Concentration
≤0,5
EC/CAS
231-100-4/7439-92-1
Name of the chemical
Blei, massiv: [Partikeldurchmesser ≥ 1 mm]
Concentration
-0,05
Listed in
EC/CAS
231-111-4/7440-02-0
Name of the chemical
Nickel
Concentration
-0,2
General Information
Version
13
Revision date
2017-08-24
Product name
WROUGHT ALUMINIUM PRODUCTS, 6xxx SERIES ALLOYS
Product Synonyms
6xxx series alloys, Alclad 6061 * C02U, C03T, CO3U, C04J, C04T, C05T, C14N, C16N, C17T, C211, C25T, C333, C34P, C36P, C38P, C39P, C400, C40H, C41P, C420, C43P, C44P, C456, C45A, C45E, C593, C63B, C703, C704, C73H, C74H, C76E, C87H, C95T, C989, CA65, CB90, CE84, CH68, CU74, CZ19, CZ26, C32T, C40T, C58P, C74W, C95U, C83Z, C412F, C411F, C83S, C452F, C16T, C471F, C472F, C485F, C41H, C439F, C61B, * C61B, C532F, C710, C81U, C57H, C22Z, C501F, C593F, C020D, C010D, C79A, C030D, C31P, C37Z, C02T, C040D, C629F, C6...
Chemical name
Mixture
REACH No
01-2119529243-45-XXXX;
1.2.1 Relevant identified uses
Various fabricated aluminium parts and products
1.2.2. Uses advised against
Does not include alloys: C217H, C228H, C524F, 6012, 6018, 6026, 6042, 6064, 6064A, 6068, 6262, C6262,C6262V (See SDS Number 390); C213H, C366, C533F, 6012A, 6020, C6020, 6021, 6023, 6028, 6040, 6041, 6262A (See SDS Number 723); C210, C215H, C26N (See SDS Number 973); C7A5, (See SDS Number 1008); C016D, (See SDS Number 807) Commercial or industrial use
Emergency telephone
+1-703-527-3887, +1-800-424-9300, +1-412-553-4001
Icons in SDS
Company Information
company name
Arconic Inc
e-mail address of the competent person responsible for the Safety Data Sheet
SDSInfo@arconic.com
GHS Information
Signal word
None
Section 2
SECTION 2: Hazards identification
Classification according to Regulation (EC) No 1272/2008 as amended Classification of the substance or mixture Classification
Environmental hazards
Hazardous to the ozone layer Not applicable Specific hazards Chips, fines and dust in contact with water can generate flammable/explosive hydrogen gas These gases could present an explosion hazard in confined or poorly ventilated spaces Non-combustible as supplied. Small chips, fine turnings, and dust from processing may be readily ignitable Explosion/fire hazards may be present when (See Sections 5, 7 and 10 for additional information) Dust or fines are dispersed in air Dust and fines are in contact with certain metal oxides (e.g., rust, copper oxide) Molten metal in contact with water/moisture or certain metal oxides (e.g., rust, copper oxide)
Contains
†Lead, ‡Nickel, Aluminium, Chromium, Copper, Iron, Magnesium, Manganese, Silicon, Zinc
Hazard pictograms
None.
Signal word
None.
Hazard statements
May form combustible dust concentrations in air.
Prevention
Observe good industrial hygiene practices. Prevent dust accumulation to minimize explosion hazard.
Response
Not available.
Storage
Keep dry. P402 Store in a dry place.
Disposal
Reuse or recycle material whenever possible. P501 Dispose of contents/container in accordance with local/regional/national/international regulations.
Supplemental label elements
None.
2.3 Other hazards
None known.
2.1 Classification of the substance or mixture
Classification This substance or mixture does not meet the criteria for classification as dangerous in accordance with Directives 67/548/EEC or 1999/45/EC and/or Regulation (EC) No 1272/2008 including all applicable amendments. However, it contains a substance for which there are Community workplace exposure limits. This Safety Data Sheet is available upon request. Classification according to Regulation (EC) No 1272/2008 as amended Environmental hazards Hazardous to the ozone layer Not applicable Specific hazards • Chips, fines and dust in contact with water can generate flammable/explosive hydrogen gas. These gases could present an explosion hazard in confined or poorly ventilated spaces. Non-combustible as supplied. Small chips, fine turnings, and dust from processing may be readily ignitable. Explosion/fire hazards may be present when (See Sections 5, 7 and 10 for additional information): • Dust or fines are dispersed in air. • Dust and fines are in contact with certain metal oxides (e.g., rust, copper oxide). • Molten metal in contact with water/moisture or certain metal oxides (e.g., rust, copper oxide).